ICartech Aurora GX730E Operation instructions manual - Installation and Uninstall
EN - 22
Installation and uninstall
Notes of installation
(1) Before installation, please make sure proper
connections are conducted and the unit
operates normally. Improper connection may
result in damage to the unit.
(2) Use only accessories designed and
manufactured for this unit and other
unauthorized accessories may result in
damage to the unit.
(3) Before installation, please fasten all power
cables.
(4) DO NOT install the unit in the place where
close to hot area to prevent damage to
electrical components such as the laser
head.
(5) Install the unit horizontally. Installing the unit
more than 30 degree vertically may result in
worse performance.
(6) To prevent electric spark, connect the
positive pole first and then the negative pole.
(7) DO NOT block the cooling fan exit to ensure
sufficient heating dissipation of this unit, or it
may result in damage to this unit.
Unit Installation
Method A
(1) Insert mounting bracket into dash board,
choose appropriate mounting tab according
to the gap width, bending the mounting
tab outwards with a screwdriver to fix the
mounting bracket in place.
(2) Use 2 pieces of M5×5 cone shaped screw to
fix two assemble bars on both sides of the
unit(see picture 1)
(3) Screw in 1 piece of M5×24 to the hole of the
unit back and put on a rubber sheath over
the screw.(see picture 2)
(4) Insert the unit into the bracket, fasten
the M4×6 screw to the fireproofing board
available at the back of the dashboard, and
use 4 pieces of M2×2 screw to lock the
assemble bars and the mounting bracket in
position.
Note:
According to the depth of the opening, use
different length of assemble bar accordingly.
If the opening is too shallow, the monitor may
be extended out 10mm from the dashboard.
Method B
(1) Insert this unit directly to the opening of the
dashboard.
(2) Place M4×3, M5×5 cylindrical screw or M5×5
cone shaped screw through the holes of the
mounting frame located inside the opening
to holes of the unit and fasten the screws to
left & right.