Icetro SSM- 420 User Manual

Summary of SSM- 420

  • Page 1

    Slush & smoothie machine user manual ssm-180, 280, 420, 560, 52(mini) · the product has been designed for indoor use only. So do not use it outdoors. · before use of the product, be sure to become familiar with this manual. Keep the manual in a convenient place for quick and easy reference. · this m...

  • Page 2

    2 contents 1.Names of parts 3~7 2.Overview 8 3.Safety signs, symbols, and labels 8 4.Safety instructions 9 5.Installation requirements 10 6.Safety cautions for operation 11 7.Operation procedure 12~19 7.1 controllers 7.2 operations 7.3 cleaning and sterilization procedure 7.3.1 disassembling the pro...

  • Page 3

    1. Names of parts exterior and parts model : ssm-52 3.

  • Page 4

    4 model : ssm-180

  • Page 5

    5 model : ssm-280

  • Page 6

    6 model : ssm-420

  • Page 7

    7 model : ssm-560 ssm-52 : see the part list..

  • Page 8

    8 the warnings and safety instructions in this manual do not cover all possible conditions and situations. While operating, moving or cleaning this product, manipulate it carefully based on common sense. If a bad and non-understandable symptom happens, feel free to contact the purchased site or serv...

  • Page 9

    9 4.Safety instructions be sure to use the grounded consent. It may cause a failure or electric shock. Do not move the product by pulling the power plug. It may cause a failure or electric shock. Do not forcibly bend the power plug or place any heavy material on it. It may cause an electric shock or...

  • Page 10

    10 5. Installation requirements do not install the product near the heat generating source. It may cause a fire. Do not install the product in a humid, dusty, or water (e.G. Rain) splashing place. It may cause an electric shock or fire. Do not install the product near combustible gases or inflammabl...

  • Page 11

    11 6.Safety cautions for operation keep away any flammable materials. ▶ it may cause a fire or explosion due to electric spark. If the product makes heavy noise or does not operate properly, remove the power plug and contact the service agency. ▶ it may cause an electric shock or fire. Do not use an...

  • Page 12

    12 caution! This product must not be used by the persons with poor mental or physical condition, or the persons without experience or knowledge (including children). If those persons use the product, a responsible person must manage the use of the product. Guide children not to play with the product...

  • Page 13

    13 7.1 controllers the product is equipped with the power switch. Canisters operate by each individual switch. You can use both soft (refrigeration) drinks and granita (smoothie, slush). In the refrigeration mode, the temperature of the drink is controlled by the thermostat. In the freezing mode, th...

  • Page 14

    14 7.2 operations ① adjusting the granita viscosity: the optimal granita viscosity is set by the manufacturer. To change the viscosity, rotate the control bolt on the rear of the product as follows: (see figure 4.) - to make thicker granita, rotate the control bolt to the right (clockwise). - to mak...

  • Page 15

    15 7.3 cleaning and sterilization procedure 7.3.1 disassembling the product ⑦ before operating the product again, check whether lumps of ice have been formed. If any lumps of ice are in the canister, remove them before switching on the product. If you operate the product in refrigeration mode during...

  • Page 16

    16 ② lift the front of the canister to unlock the latch (figure 5) and pull out the canister to the front. (see figure 6) ③ remove the spiral by pulling out (figure 7) and remove the packing cushion. (see figure 8) (figure 5) (figure 6) (figure 7) (figure 8) ④ remove the rubber cushion. (see figure ...

  • Page 17

    17 7.3.2 cleaning the product ① prepare the solution mixed with five liters of warm water and kitchen detergent. Do not use a strong detergent. ② after inserting the mixed solution that does not harm the food, turn on the slush supply switch to extract the solution. ③ frequently empty the remaining ...

  • Page 18

    18 7.3.3 sterilizing the product 7.3.4 assembling the product sterilization is performed before operating the product. After sterilization, do not leave the product for a long time. ① wash your hands with an anti-bacterial soap. ② according to the food safety regulations and manufacturer specificati...

  • Page 19

    19 the site sterilization can be performed additionally after parts sterilization but it cannot replace the parts sterilization. ① according to the food safety regulations and manufacturer specification, prepare five liters of warm (45 to 60 ℃ ) sterilization solution (remaining chloride 100 ppm). ②...

  • Page 20

    20 8. Daily check ① daily check: it checks any possible leak through the packing or gasket. If leak happens through the packing or gasket even though properly assembled, check the use of improper grease or parts wear. If necessary, replace parts. 8.1 repairing the product (by qualified engineer only...

  • Page 21

    21 9. Specifications model name product name ssm-180 ssm-280 ssm-420 ssm-560 ssm-52 (mini) case insulation compressor condenser evaporator refrigerant provisions size (w × d × h) 213 × 480 × 832 stainless steel urethane foam 320w 1.8a 1ea 9 w or below r-134a 6 ℓ× 1tank torque and tc control r-404a 6...

  • Page 22

    22 10. Circuit diagram ssm-52 ssm-180 circuit diagram circuit diagram.

  • Page 23

    23 ssm-280 ssm-420 ssm-560: two ssm-280s are applied circuit diagram circuit diagram.

  • Page 24

    24 11. Before calling service failure if power is not supplied 1. Power is not supplied from the outlet. Deformation of the spiral and canister. (it can happen when hot water (80 ℃ or above) is used while cleaning and sterilizing the product.) the material level is too low. The material is too much ...

  • Page 25

    25 12. Part list ssm-52 in case assembly no 1 2 3 4 5 6 7 8 9 10 condender a’ssy fan bkt fan motor fan motor bkt pcb a’ssy control box comp tc column back a’ssy soleniod valve no item item.

  • Page 26

    26 ssm-52 out case assembly no 1 2 3 4 5 6 7 8 9 10 11 12 filter guide side panel l base plate back panel switch a’ssy side panel r bolt wrench foot rubber front panel drain box drain box cover filter no item item.

  • Page 27

    27 ssm-180 in case assembly no 1 2 3 4 5 6 7 8 base plate fan condenser a’ssy bracket pcb mg trans pcb comp comp base no item item.

  • Page 28

    28 ssm-180 out case assembly no 1 2 3 4 5 6 7 8 9 side panel l base plate back panel fillter side panel r drain box drain bolt drain box cover front panel no item item.

  • Page 29

    29 ssm-280, 420 in case assembly no 1 2 3 4 5 6 7 8 9 10 condender a’ssy fan fan motor bkt fan motor tc column back ass’y soleniod valve comp trans pcb ass’y no item item.

  • Page 30

    30 ssm-280, 420 out case assembly no 1 2 3 4 5 6 7 8 9 10 11 12 13 filter guide filter back panel base plate side panel l front pannel drain box cover drain box drain bolt bolt wrench foot bubber side panel switch side panel r no item item.

  • Page 31

    31 ssm-560 in case assembly no 1 2 3 4 5 6 7 8 9 10 11 12 13 14 ass’y soleniod valve bkt sol v/v column back tc axifan fan bkt pcb pcb ass’y trans comp fan motor base plate fan motor bkt fan condender a’ssy no item item.

  • Page 32

    32 ssm-560 out case assembly no 1 2 3 4 5 6 7 8 9 10 11 12 13 column cover b-l base plate back panel side panel r column cover b-r foot caster front panel bracket drain box drain box drain box up switch ass’y ruber side panel l no item item.

  • Page 33

    33 canister assembly no 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 canister cover canister spiral packing back dasher shaft tension bolt joint spring insert joint spring moter cover drum moter micro switch ass'y drum base canister packing cushion packing down redenar ass’y pin lever...

  • Page 34

    34 1. A product failure has occurred while operation. 2. First turn off the power switch and remove the power plug. 3. Contact the service agency. 4. The service engineer visits and performs service upon call. 5. The repair is finished! ! 6. When you are using the clover service of the manufacturer,...

  • Page 35

    35 product warranty card product name model name serial number purchased date warranty expiration customer address customer name phone number warranty period 1 year after purchasing the product year____ month______until year____ month______ day____ year____ month______ day____ slush & smoothie machi...

  • Page 36

    Online internet service http://www.Icetro.Com 3240193-00 001.