J&B Importers Miami Sun Assembly Manual - Step 6) Attaching Pedal
R
Step 6) Attaching Pedal
s
A. Each pedal axle is marked with "R" (right) or "L" (left). Install them in their correct
position. Note that the left pedal tightens by turning counter clockwise and that
the right tightens clockwise.The right side is the chain wheel side.
10
(Fig. 7)
Step 7) Axle Key Installation
A. Align axle slot with adapter slot.
Tap key into slot.
B. Check the following:
1. Axle flange is flush against unit
outer bearing.
2. Freewheel is all the way to the right
and lined up with front chainwheel
so that the chain is straight.
(Check FIG.6)
3. Now tighten set screws on adapter
securely.
(Fig.8)
Step 8) Attaching Rear Wheels
A. Both wheels are the same. The hub flanges have three holes that fit the studs on the
axle flange. Install the drive wheel first,(right side). Add axle washer on the outside
and snug down locking nut.
Over-tightening
will damage the bearings.