Summary of Club-4505
Page 1
En owner's manual jbl club-704/ club-4505/club-5501 amplifiers.
Page 2
Thank you for your purchase . . . Your jbl product has been designed to provide you with the performance and ease of operation you would expect from jbl. • please take time to read your owner's manual in its entirety before operating or installing your amplifier. • keep the owner's manual for your a...
Page 3
Jbl club table of contents chapter 1: pictorial index of input connections ....................................................................................................... 01 chapter 2: installation and wiring ......................................................................................
Page 4
1 chapter 1: pictorial index of input connections club amplifier top panel club amplifier front panel club amplifier back panel power protect 1 2 3 4 5 8 10 12 13 11 9 7 6 -.
Page 5
Jbl club 2 chapter 2: installation and wiring what's in the box: 1 amplifier 2 spare fuses (x3 with club-4505) 4 rca adapters (x2 with club-5501) quick-start guide precautions: important: disconnect the vehicle’s negative (–) battery terminal before beginning the installation. • always wear protecti...
Page 6
3 1. Power indicator: the light will illuminate in white when the amp is receiving power and playing. 2. Protect indicator: the indicator will illuminate in red if the amp enters protect mode in the event of conditions such as over/under voltage, short circuit, amplifier output circuit failure, or e...
Page 7
Jbl club 4 ° 3-channel operation: connect the stereo speakers to the front terminals, as described above. Connect the single speaker’s + lead to the rear l+ terminal, and the - lead to the rear r- terminal. ° 2-channel (bridged) operation: connect one speaker’s + lead to the front l+ terminal, and t...
Page 8
5 • the club-4505 features front l+, l-, r+, and r- terminals; rear l+, l-, r+, and r- terminals; and sub + and - terminals. ° 5-channel operation: connect the front left speaker to the front l+ and l- terminals, and the front right speaker to the front r+ and r- terminals. Connect the rear left spe...
Page 9
Jbl club • the club-5501 features two positive (+) and two negative (-) terminals. To power two subwoofers in parallel, connect one sub’s positive (+) and negative (-) leads to the positive and negative terminals on the left, and the other sub’s positive and negative leads to the positive and negati...
Page 10
7 use a small phillips screwdriver to loosen the adapter’s set screws and insert the speaker wires into the holes on the back of the adapter. Tighten the set screws to secure the wires. Always connect the (+) speaker wire to the adapter’s (+) terminal and the (–) speaker wire to the adapter’s (–) te...
Page 11
Jbl club 8 9. Input level selectors (gain): input level controls. Use these to match the amp’s input sensitivity to the output level of your source unit. See 17 for a recommended adjustment procedure. (see setting the input levels in chapter 3 for a recommended adjustment procedure.) 10. Crossover-f...
Page 12
9 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 12. Adas assign (club-704 and club-4505 models only): if you’ve connected the amp to an advanced driver assistance system (see 13, next), this dial allows you to select the speaker over which you’ll hear adas messages. Turn the dial to fl for the front left speaker,...
Page 13
Jbl club chapter 3: operations setting the input levels: to match your amplifier’s input sensitivity (gain) to your source unit’s output level, we recommend the following procedure: a. Turn both input level controls counterclockwise to min (minimum). B. Play a dynamic music track through your source...
Page 14
11 chapter 4: troubleshooting problem: no audio and power indicator is off. Cause and solution: no voltage at batt+ and/or rem terminals, or bad or no ground connection. Check voltages at amplifier terminals with vom. Problem: no audio and protect indicator flashes every 4 seconds. Cause and solutio...
Page 15
Jbl club 12 problem: music lacks dynamics or "punch." cause and solution: speakers are not connected properly. Check speaker connections for proper polarity. Problem: amplifier fuse keeps blowing. Cause and problem: the wiring is connected incorrectly or there is a short circuit. Review installation...
Page 16
13 © 2016 harman international industries, incorporated. All rights reserved. Infinity is a trademark of harman international industries, incorporated, registered in the united states and/or other countries. The bluetooth ® word mark and logos are registered trademarks owned by bluetooth sig, inc. A...