J&J Electronics Color Splash Installation And Operation Manual - Memory Mode
pg 9
DEACTIVATION THE COLOR LOCK FEATURE
Turn the pool light power off and then back on again within 2 seconds. Color Splash
will resume light show.
MEMORY MODE
When your Color Splash LED light fixtures are turned off for more than 10 seconds,
the solid color or light show on display will be stored. The next time the power is
turned on, the fixture will resume displaying that same color or light show.
RESET/SYNCHRONIZE MODE
To activate the reset mode, turn the power off and back on again within 1 second,
three times in a row (off/on, off/on, off/on). All the fixtures connected to the switch
will indicate they have been reset and synchronized by flashing red four times. When
you rest the Color Splash LED light fixtures they will go back to the Northern Lights
light show.
1. NORTHERN LIGHTS (FACTORY DEFAULT LIGHT SHOW)
Show: Slow cross-fade through all seven solid colors.
Cycle: Two minute color sequence cycle with slow cross-fade between colors. Fixture
will hold on each solid color for 8 seconds before moving to the next.
2. SUPER NOVA
Show: Quick and random flashes through all seven solid colors.
Cycle: Random fast change between solid colors in half second intervals.
NOTE: Your Color Splash LED light fixtures are “synchronous”, meaning you can experience
the same light shows in your pool and spa at the same time. However, all of the pool lights
must be on the same electrical circuit for this feature to be operational. Please consult a
qualified electrician to determine your specific pool and spa circuit configuration.
DESCRIPTION OF LIGHT SHOWS AND SOLID COLORS
ACTIVATING THE COLOR LOCK FEATURE
Turn the pool light power off and then back again in 2 seconds. Color Splash will
“lock” on the color it was displaying at the time when you turned it off.