J&J Electronics Color Splash Installation And Operation Manual - This Device Is
Always disconnect power to the pool and/or spa light at the circuit breaker panel
before attempting to service the light. Failure to do so could result in serious injury
or death due to electrical shock. Installation must be performed in accordance with
all applicable federal, state & local installation codes and ordinances by a licensed or
certified electrician or a qualified pool professional. Improper installation may result
in death or serious injury to pool and/or spa users, installers or others due to electrical
shock. In addition, improper installation may cause property damage.
This device is
not intended for use in anything other than in-ground pools/spas.
WARNING! Risk of electrical shock or electrocution
Do not, under any circumstances, splice wire underwater or behind the light niche
during the installation of this light.
Color Splash LED Pool and Spa light fixtures are operated through the light’s switch.
No special controller or interface is required. Use a junction box to connect and
operate multiple lights with a single switch.
The following steps detail installation of the Color Splash LED light fixture into a new
pool and/or spa construction. Read this section in its entirety prior to beginning any
installation.
WARNING! Important Safety Information for Light Installation
INSTALLER NOTICE: This light’s external cord cannot be replaced and should be
handled with care. Any damage to this external cord necessitates replacing the light.
pg 2
OPERATION FOR 120VAC AND 12VAC
COLOR SPLASH LED POOL AND SPA LIGHT FIXTURES
COLOR SPLASH LED POOL AND SPA LIGHT FIXTURES INSTALLATION
(NEW POOL AND/OR SPA CONSTRUCTION)
INSTALLER NOTICE: A licensed electrician must complete the following steps prior to
installation of this light in a new pool or spa construction.
RATED FIXTURE LIFE: The illumination generated by Color Splash LED light fixtures
are based on Light Emitting Diode (LED) technology. The average expected fixture
life is rated 50,000 elapsed time hours under normal operating conditions. Pool Water
Temp: 33°F to 97°F (1°C to 36°C), humidity: 0-95% non-condensing.