J&J Electronics Color Splash Installation And Operation Manual - Code Requirements.
The following steps detail installation of the Color Splash LED light fixture into an
existing pool. Read this section in its entirety prior to beginning any installation.
1. Disconnect the main electrical switch or circuit breaker and the switch which
operates the installed light.
2. Remove the existing light per the original manufacturer’s instructions. Place the
light fixture on the deck.
3. Leaving the light fixture on the deck, cut the light cord. Be sure to leave at least
six (6) inches of cord in order to connect it to the replacement light cord. Discard the
light fixture.
4. Remove the existing cord by pulling it up out of the niche and onto the deck.
Failure to bring the pool and/or spa electrical system up to current code requirements
prior to light installation may create an electrical shock hazard resulting in death or
serious injury to users, installers, or others due to electrical shock, and may also cause
property damage.
WARNING! Pool or spa electrical system must meeting current
code requirements.
4" Min.
48" Min.
18" Min. Top of Lens
to Water Level
8" Min. Junction Box
or Low Voltage
Transformer to the
Max. Water Level of Pool
To: GFCI, Circuit Breaker,
and Power Source
Rigid Conduit
#8 AWG Ground
Connector Bonding
Lug is Located at
Rear of Niche
Coil 4 ft. of Power
Cord Around Fixture
Concrete Must Be Cut
Back Around Niche to
Allow for a Compacted
Plaster Seal
Figure 1.
EXISTING CONSTRUCTION INSTALLATION STEPS
(ONCE ALL ELECTRICAL REQUIREMENTS ARE MET)
pg 6