J. W. Davis & Company D-250AL User Manual - page 3
NEW TECHNOLOGY
OLD RELIABILITY
J.W. Davis & Company
• 3030 Canton Street • P.O. Box 710219 • Dallas, Texas 75371-0219
Sales 800-527-5705 • Fax 800-388-9106 • Corp 214-651-7341 • Fax 214-939-0328 • sales@jwd.com • www.jwd.com
The Mark of the Professional...
I. UNPACKING PROCEDURES
INSPECTION
This unit was carefully checked and packed before leaving the factory. However, each shipment should be
inspected by observing the shipping container and unit for indications of improper handling. If damage has
been found, an immediate claim should be made to the shipping company. Keep all cartons and packing
material for inspection. Do not call J. W. Davis & Company or return the shipment to J. W. Davis &
Company until the shipment has been examined by the shipping company. Failure to permit the shipping
company to examine the shipment at the arrival point may void subsequent settlement. If there is a problem after
the shipping company has made its inspection, then call Customer Service at J. W. Davis & Company for
assistance.
INITIAL PERFORMANCE CHECK
Complete the inspection with an initial performance check. Connect a test speaker to the 8-ohm direct output
terminals. Then, connect a tuner, tape deck, or CD player to the auxiliary input and set the controls for operation.
If the unit should be inoperable and no damage is noted, please contact J. W. Davis & Company’s Customer
Service Department for directions (800-527-5705).
III. INSTALLATION INFORMATION
RACK MOUNTING
For best results use a 10-32 class UNF-2B or 12-24 class UNC-2B rack and 0.625 inch machine screws (metric:
M5X8-6H or M6X1-6H, 15.88mm). It is recommended that the drive of these screws be phillips to protect the
finish from unnecessary scratches. Nylon or plastic washers are recommended which will not only help protect
the finish but also aid in retaining the screws.
CONVECTION, FAN COOLING, AND VENTILATION
This unit is cooled via convection and therefore designed for continuous operation. Do not block the unit’s
heatsink fins or the vent holes located in the cover. If the unit will be rack mounted, a cooling fan must be used
that is capable of exhausting not less than 300CFM. The fan must be mounted to the inside top of the rack,
above the amplifier.
II. PRODUCT OVERVIEW
-3-
Outputs:
4-8 ohm/25V/70.7
Tel-Page
Microphone
Input
Patch Feature
For Additional Amplifier
Two Aux Inputs
Strapped
in Parallel
Music Input
Source
Inputs
Auto-Mute
Amplification:
250W
D-250AL POWER AMPLIFIER
CAUTION: TO PROTECT THE SPEAKER FROM DAMAGE, DO NOT TURN
THE UNIT ON UNTIL ALL CONNECTIONS HAVE BEEN MADE. IN ADDITION,
BE SURE THAT THE UNIT IS GROUNDED BEFORE TESTING.