1. DL manuals
  2. Jack LaLanne's
  3. Juicer
  4. CL-003AP
  5. Operating Manual

Jack LaLanne's CL-003AP Operating Manual

Summary of CL-003AP

  • Page 1

    E-1181 e-1189 operating manual do not operate the power juicer tm before reading this entire manual. For household use only stainless steel.

  • Page 2: Table of Contents

    Table of contents important safeguards . . . . . . . . . . . . . . . . . . . . . . . 3-4 safety features . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 parts list . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 disassembly . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 3: Important Safeguards

    3 important safeguards read these safeguards carefully before using this product! When using electrical appliances, basic safety precautions should always be followed including the following: • read all instructions. • not for use by children! Keep out of the reach of children to avoid injury. This ...

  • Page 4: Safety Features

    4 • the juicer will not run if the unit is not properly assembled. The motor has a built-in safety feature that will not allow the power to turn on unless the locking bar is locked in place. • do not use outdoors. • be sure to turn switch to off position after each use of your juicer. Make sure the ...

  • Page 5: Parts List

    5 pusher filter blade receptacle removable non-drip spout pulp collector parts list crescent tool (for tightening and removing blade) (pegs fit into blade.) locking bar screw peg base lid with pulp guard chute pulp guard lip main unit (fully assembled) brush (crescent tool pegs fit here to tighten.W...

  • Page 6: Disassembly

    6 disassembly important: before disassembling the unit make sure you turn the power off and unplug the machine from the electrical outlet. Pulp collector locking bar 2 lid with pulp guard step 1: remove pusher from the chute. Step 2: lower the locking bar (silver) into position as shown. Base 1 pulp...

  • Page 7: Assembly

    7 assembly assemble as shown step 2: place receptacle on the base, with juicer spout facing direction of locking bar. Settle receptacle into alignment. Step 3: place filter inside receptacle, matching the opening on its bottom to the screw peg connected to the base. Step 1: place base on a dry flat ...

  • Page 8: Assembly

    8 assembly (cont .) step 5: place lid with pulp guard attached on top of receptacle, making certain it is snugly aligned with the pulp guard facing in the opposite direction of the juice spout. Lock lid into place by lifting locking bar up until it clicks into grooves located on both sides of the li...

  • Page 9: To Clean The

    9 step 1: locate removable juice spout locking mechanism on the bottom side of the receptacle. Note: juice spout will be in the locked position. To clean the juice spout step 2: to unlock, turn locking mechanism counter-clockwise, lining up notch with juicer spout hinge pivot arm. Step 3: lift up ju...

  • Page 10: Equivalents

    10 equivalents tomatoes 4 medium firm tomatoes = 2 cups of juice 4 medium firm tomatoes = 1 cup of pulp carrots 5 large carrots = 1 cup juice 5 large carrots = 1 cup pulp cucumber 1 large cucumber = 1 cup juice zucchini & squash 5 small zucchini = approx. 1 cup juice 5 small zucchini = approx. 1/2 c...

  • Page 11: Troubleshooting

    11 the motor does not run after being switched on. The motor is running with a loud noise and excessive vibration. The motor overheats causing the power to automatically shut off. Juice splashes from the rim of the receptacle. • check to see if unit is plugged in. • locking bar is not locked in plac...

  • Page 12: Common Questions

    12 q . Why won’t the power turn on? A. First, make certain the juicer’s ac cord is plugged into a working 110v electrical outlet, then check that the switch is in the on position. Then, check that all parts are assembled properly. The unit has a built-in safety device that will not let the motor tur...

  • Page 13

    13 q . Can i add ice or liquid to the power juicer? A. No, adding ice or any other substance that is liquid at room temperature will cause an “overflow” in the receptacle. If needed, ad these liquid ingredients after the juicing process. Q . How can i get berry juice to come out of the receptacle? A...

  • Page 14: Jack Lalanne Power Juicer

    14 jack lalanne power juicer limited lifetime warranty the manufacturer warrants that your jack lalanne power juicer is free of defects in materials and workmanship and will, at its option, repair or replace any defective juicer that is returned . The jack lalanne power juicer motor is warranted for...

  • Page 15: Replacement Parts Kit #1

    Yes! Please send me the following items: one accessory kit for only $19.99 plus $6.99 s&h. Total $26.98. Replacement parts kit #1 for only $34.99 plus free s&h. Total $34.99. Replacement parts kit #2 for only $19.99 plus free s&h. Total $19.99. Visa mastercard discover exp. Date____ credit card #___...

  • Page 16: Stainless Steel

    Pjpro_man_tp_eng_ v6_110420 © 2011 tristar products, inc. All rights reserved. Distributed by: tristar products, inc. Fairfield, nj 07004 we are very proud of the design and quality of our power juicer. This product has been manufactured to the highest standards. Should you have any problem our frie...