Summary of Elite
Page 1
Operating manual.
Page 2
Power juicer elite 4 5 6 7 10 11 13 14.
Page 3: Contents
Power juicer elite contents 3 contents important safety information helpful hints parts/ main unit assembly/ main unit assembly/ e-z loader attachment disassembly/ main unit cleaning your power juicer troubleshooting 4 5 6 7 10 11 13 14.
Page 4: Before Using This Product!
Read these safeguards carefully before using this product! When using electrical appliances, basic safety precautions should always be followed including the following: • always remove power cord from electrical outlet before assembly or disassembly. • not for use by children! Keep out of the reach ...
Page 5: Additional Safeguards
Additional safeguards follow these helpful hints to obtain the best results from your power juicer elite. • do not put any fruit or vegetables in your machine until power is turned on and the motor is spinning. • allow unit to run for at least 10 seconds before juicing. • do not force food into the ...
Page 6: Assembly
Power juicer elite 6 parts/main unit lip chute screw peg micro safetyswitch main unit (fully assembled) receptacle removable non-drip spout pegs (pegs fit into blade.) filter blade e-z loader attachment with e-z plug lid with pulp guard pulp collector pusher base locking bar assembly main unit parts...
Page 7: Note: Refer to Page
Assembly/main unit 7 step 2 : place receptacle on the base, with juicer spout facing the same direction as locking bar. Settle receptacle into alignment. Step 1 : warning: never plug the power cord into an electrical outlet before unit is fully assembled . Place base on a dry flat surface with locki...
Page 8: Note: Refer to Page
Power juicer elite 8 assembly/main unit step 4 : place blade inside filter, centered over screw peg. Using orange crescent tool, place its pegs into the holes on the blade. Turn clockwise while holding the filter and receptacle in place until tight (as shown). Step 6: place lid with built-in pulp gu...
Page 9: Main Unit
Power juicer elite assembly/main unit 9 main unit step 9: insert pusher into chute. Always use pusher to feed fruits and vegetables into unit. Push gently, never force. The blade will do the work. Warning: when juicing cherries make sure the power is off and blade has stopped spinning before removin...
Page 10: Assembly
Assembly step 1 : remove pusher from chute. Insert the e-z loader attachment into the chute lining up the flat side of the container base to the flat side of the chute. Secure attachment. • to avoid personal injury: never look inside the chute while the machine is running. Especially when using frui...
Page 11: Disassembly
Step 2 : lower the locking bar (silver) into position as shown until it rests on flat surface. Step 3 : remove lid with pulp guard. Step 4 : remove pulp collector. Disassembly step 1 : warning: before disassembling the unit make sure the power is off and remove power cord from the electrical outlet....
Page 12: Disassembly
Pusher step 5 : use the crescent tool to remove the blade. Place the two pegs at either end of the crescent tool into the two holes on the blade. Press down and turn counter- clockwise while holding filter and receptacle to unlock the blade. Remove blade carefully. Disassembly step 6 : remove filter...
Page 13: Cleaning Your Power Juicer
• turn off the power switch and wait until the motor completely stops. • with dry hands, unplug the power cord from electrical outlet. • disassemble the machine. (see disassembly instructions.) • wipe base with a soft damp cloth or sponge. Do not submerge base in water. Do not spray with water or an...
Page 14: Problem
The motor does not run after being switched on. The motor is running with loud noise and shaking. The motor overheats causing the power to automatically shut off. The motor is spinning and processing fruit/ vegetables but nothing is coming from spout. Juice is leaking from the receptacle but nothing...
Page 16
Pjelite_man_tp_eng_v6_100122 © 2008 tristar products, inc. All rights reserved. Distributed by: tristar products, inc. Wallingford, ct 06494.