Summary of I-35
Page 1
Jadis i-35 integrated amplifier owner's manual.
Page 2
Table of contents introduction warning unpacking and checking description installation instruction tube position how to match your amplifier to your loudspeaker how to turn on your amplifier maintenance i-35 specifications.
Page 3: Enjoy Your Amplifier.
Introduction at jadis , we are very proud to release a new product after a lengthy period of experimentation and trial. Our jadis amplifier is therefore the result of long months of technical research and countless hours of listening. Enjoy your amplifier. We thank you for your trust in our product..
Page 4
Warning read this document thoroughly before any manipulation. Then read step by step when installing..
Page 5
Unpacking and checking the i-35 amplifier has been packed in a box that has been specially designed for it. Do not throw away this box as it will be needed for re-packing the unit when it has to be returned to the factory for maintenance or upgrading. Please note that the warranty will be considered...
Page 6
Description front view on the front side of the integrated, you will find: - the power switch on/off. - the power led is green when the unit is turned on. - the volume control, it adjusts the sound amplitude. - the balance control. When you turn it, the sound is moving from the left to the right cha...
Page 7
Installation instructions read this carefully. Optimum listening quality is obtained when the following recommendations have been observed step by step. 1 - each i-35 intgrated amplifier unit is packed with its own tested tubes. Place the tubes: be careful do not mix up the tubes and place them imme...
Page 8
Tubes position first of all, remove the grid which protects the tubes sockets (be sure the mains connector is unplugged). Attention: for mounting the tubes, do not force them, this may damage the sockets. Be careful at dressing power tubes (a, b, c and d) because they have stop pins on the central p...
Page 9
How to match your amplifier to your loudspeakers the load impedance is pre-adjusted in the factory for loudspeakers from 4 to 8 ohms. Nota: for a good listening level, choose loudspeakers with an efficiency of more than 90 db. Internal adjustment of impedance: warning for connecting the speakers: th...
Page 10
How to turn on your amplifier in order to get the best performance from your jadis amplifier, it is necessary to follow carefully the instructions below: 1- check that the power switch is off. 2- verify that the volume control is set to minimum. 3- connect the loudspeaker wires to the red and black ...
Page 11
Maintenance your jadis amplifier is adjusted for a nominal voltage corresponding to your country's electrical network. If the integrated amplifier fails to operate: 1 - turn off the unit immediately. 2 - unplug all the cables. 3 - do not forget the mains cord. 4 - contact your jadis dealer for diagn...
Page 12
I-35 specifications load impedance: adjustment by internal wiring. Should be done by a qualified technician 1 to 16 ohms output power at 1khz: 30 watts bandwidth at -3 db: 20 hz to 20 khz input impedance: > 100k ohms input sensitivity for rated output: 100 mv consumption: 275 w dimensions: 50 x 33 x...