Summary of Tango
Page 2
Contents n brief introduction…………...…………………………..…....1 n before use……………………………………………………..1 1. Overview …………………………………………………...……1 2. Charging for headset.. ……………………………………………2 n getting started……..…………………………………………3 1. Turning on/off the headset …………....……………………......3 2. Wearing the headset ..........
Page 3
Thank you for purchasing the k3 sport in-ear headphones. Please read this user guide carefully before use. N brief introduction the k3 tango is a sport in-ear bluetooth stereo headset; designed for ultimate portability and functionality within today’s mobile world. Ipx 4 certified, water, moisture ...
Page 4
2. Charging for headset the headset comes with a built-in rechargeable battery, prior to using it, it is recommended to charge the battery completely prior to initial use. When the headset is low power, the headset emits prompt tones every 5 minutes and the red led flashes. Please recharge the batte...
Page 5
N getting started 1. Turning on/off the headset functions operation prompt tone turning on press and hold about 4 seconds until blue led flashes four raise tone turning off press and hold about 4 seconds until red led flashes four fall tone remark: in order to save power, the headset will turn off ...
Page 6
B. Choose the suitable size ear tip (s) according to your ear and comfort as following shown: c. Customize the cable management clip for optimum in-use performance 4.
Page 7
3. Pairing/connecting 1) pairing headset with bluetooth cell phone prior to using the headset for the first time, you have to pair it with a bluetooth-enabled cell phone. The pairing procedures are subject to different models of cell phones. Please refer to your cell phone user’s manual for further ...
Page 8
3）pairing headset with multi devices the headset can connect with two bluetooth cell phones at the same time. The general pairing procedures are as follows: 1) pairing the headset with device one 2) turn on the headset and place into pairing mode again, then pair it with device two 3) operate device...
Page 9
Volume down during a call short press button transfer conversation to mobile phone during a call long press about 2 seconds one short tone transfer conversation to headset during a call long press about 2 seconds one short tone microphone mute during a call long press about 2 seconds two fall tone c...
Page 10
Note: u not all the mobile phones support all the functions listed above. Different function and prompt tone according to different mobile phone. Please refer to your mobile phone user’s manual. U when the volume is adjusted to max or min, you will hear one prompt tone. U when the headset under m...
Page 11
3) connect with two cell phones functions status of headset operation end phone call #1 and answer phone call #2 during phone call #1, phone 2 has incoming call short press once retain phone call #1 and answer phone call #2 during phone call #1, phone 2 has incoming call double click button switch c...
Page 12
6. Led indicator led indicator status of headset red and blue led flashes alternately pairing mode blue led flashes once every 2 seconds not connected to device blue led flashes twice every 4 seconds connected to device red led flashes instead of blue led low battery 7. Factory reset in the status o...
Page 13
N faqs 1. What does it mean when red led flashes instead of blue led? Battery is low power, need to be recharged. 2. Why is the red led off when charging? A) please make sure the charging device connect with headset well; b) please charge the battery for 30 minutes, and then the red led will be on....
Page 14
N specifications bluetooth version bluetooth v4.0 bluetooth profiles headset, hands free, a2dp, avrcp operating distance 10meters headset music time approximately 5-6 hours headset talk time about 5.5-6.5 hours standby time about 200 hours headset charging time about 2 hours dimension headset: 30x1...