Music teaching lab system expansion kit installation.
Chapter 1 introducing the music teaching lab expansion kit the music teaching lab expansion kit allows you to add ports to your music teaching lab system. This allows you to accommodate more students. Each music teaching lab expansion kit adds 8 ports to the music teaching lab system. This allows an...
Chapter 2 installing the music teaching lab expansion kit(s) installing the music teaching lab expansion kit is straightforward and can be done by anyone with basic technical knowledge. Step 1 if the music teaching lab system is installed, switch unit off and remove all cables connected to the music...
Step 4 install the channel circuit board from the music teaching lab expansion kit into the lab hub. Make sure the plug the pins into the backplane connector correctly. Installing new channel board step 5 install the 5 standoffs into the 5 holes in the new channel circuit board to secure it to the c...
Step 6 remove any blank plates covering the newly populated connectors. Remove as needed 8 6 5 4 7 1 2 3 aux in cd in rec out mon out right left teacher remote ethernet on/off power 9vac removing blank plate step 7 replace cover and all screws. Step 8 replace all the cables that were unplugged at th...
Step 10 connect the new student boxes to the newly added channel circuit board connectors using the provided multiconductor cables. See the diagram below. Piano student box 9 10 11 15 12 13 14 16 remote ethernet teacher right mon out rec out cd in aux in 8 6 5 4 1 2 3 7 left on/off power 9vac connec...
