Keating Of Chicago 37797 Service Instructions

S E R V I C E   I N S T R U C T I O N S

INSTRUCTIONS FOR MICRO SWITCH ADJUSTMENT

FOR AUTO TOP SIDE HEAD ACTUATOR

InstMSAdjTSHeadAct

9/08

www.keatingofchicago.com

1-800-KEATING

TOP SIDE HEAD DOWN

TOP SIDE HEAD UP

TOP SWITCH AND CAM

BOTTOM SWITCH AND CAM

(2) SWITCHES

MOUNTED AS SHOWN

TOP SWITCH SHOWN

MICRO SWITCH ACTUATORS

FOR TOP AND BOTTOM

SWITCHES SEE #3 − #8

(SET SCREWS)

SEE NOTES #3 & #4 FOR TOP MICRO

SWITCH AND NOTES #6 & #7 FOR

BOTTOM MICRO SWITCH

(TOP AND BOTTOM CAMS)

SEE NOTE #3 − #8

SEE NOTE #1 − #9

*

**

*N

NO

OT

TE

E 

 T

TH

HE

E 

 T

TO

OP

P 

 A

AN

ND

D 

 B

BO

OT

TT

TO

OM

M 

 S

SW

WI

IT

TC

CH

H 

 A

AR

RE

E 

 A

AS

SS

SE

EM

MB

BL

LE

ED

D 

 I

IN

N 

 L

LI

IN

NE

E.

.*

**

*

1. Remove the limits switch black

plastic cover on the actuator.

2. Turn on the power on unit and

push the start button on the timer.

The actuator will extend the stroke

and lowers head. The motor must

stop and the stroke should stop

extending before it reaches its

mechanical stop. This movement is

controlled by the top micro switch.

3. If the motor fails to stop, manually

depress the top micro switch actua-

tor. This will disconnect power to the

actuator motor. Loosen the set screw

located on the top cam. Rotate the

top cam clockwise until the switch is

made (you should hear it click).

4. Tighten the set screw on the cam,

use blue locktite.

5. Turn on the power on unit and

push the start button on the timer

until it goes to the preset time. The

actuator will retract the stroke and

raise the head. The motor must stop

and the stroke should stop retracting

before it reaches its mechanical stop.

This movement is controlled by

bottom micro switch.

6. If the motor fails to stop, manually depress the bottom micro switch actuator. This will disconnect power to the actuator

motor. Loosen the set screw located on the bottom cam. Rotate the bottom cam counter clockwise, until the switch is made

(you should hear it click).

7. Tighten the set screw on the cam, use blue locktite.

8. Test the top side head. Verify the adjustments did not change the length of the stroke, thus preventing correct function

of the top side head. The top side cooking head must be able to reach the griddle plate. If it does not function properly

complete steps #2 - #7.

9. Reinstall the switches cover.

Tool needed: 2.5 mm Allen Wrench

Part # 037797

part # 037797