Keating Of Chicago Bob Evans Farm Series 2000 Service Instructions

BEFCal2000GasFry

10/08

THERMOSTAT CALIBRATION

SERIES 2000 GAS FRYERS

S E R V I C E   I N S T R U C T I O N S

www.keatingofchicago.com

1-800-KEATING

Calibration is not covered under warranty.

Tools: Accurate fryer thermometer

Standard screwdriver

Standard Phillips Head screwdriver

Note: Thermostat is pre-set to 350º at Factory.

1.

Turn on fryer. 

2.

Allow fryer burners to cycle on and off three times.

3.

Place an accurate thermometer in the oil. Locate thermometer

in same position for every calibration. Left rear corner of fryer

vessel is recommended.

4.

Remove (2) Pan Head Phillips screws from control panel front. 

Put screws in secure place. Lower control panel front.

Thermostatcalibration

Thermostat knob removed to reveal calibration screws.

5.

If temperature of fryer is found to be less than 15°F off, remove

the thermostat knob. Loosen the two screws in the thermostat

dial plate. Replace knob. Reset the dial plate to match the

thermometer reading.

6.

Put control panel in upright position. Fasten (2) Pan Head 

Phillips screws into holes on control panel.

For calibration over 15°F difference, contact a qualified service

company.

See note

#4 & #6