Keating Of Chicago Cutting Board with Brackets 055523 Installation Instructions

www.keatingofchicago.com

1-800-KEATING

I N S T A L L A T I O N     I N S T R U C T I O N S

CutbrdInstll

6/05

INSTALLATION FOR CUTTING BOARD 

WITH BRACKETS ON KEATING GRIDDLES

What’s needed to

complete this installation?

•

Drill Gun

•

#19 Drill Bit

•

Phillips Screw Driver

FLUSH

FLUSH

What’s included in your package?

A

PRE-ASSEMBLED MOUNTING BRACKET FOR SECURING CUTTING BOARD TO SIDE BRACKET (2x)

B

END SUPPORT BRACKET (2x)

C

RICHLITE CUTTING BOARD (1x)

D

#10 SCREWS FOR ATTACHING BRACKET TO CABINET (6x)

E

CUTTING BOARD CENTER SUPPORT FOR 48" AND LARGER GRIDDLES (1x)

1)

HOLD END SUPPORT BRACKETS IN PLACE AND MARK 3 HOLES ON EACH SIDE

OF CABINET. TOP EDGE OF BRACKET IS TO BE FLUSH WITH UPPER EDGE OF

CABINET SIDE. 90° FORM ON THE BRACKET WILL EXTEND OUT FROM THE

PERIMETER FRONT.

2)

DRILL THREE HOLES ON EACH CABINET SIDE WITH THE #19 DRILL BIT.

3)

ATTACH END SUPPORT BRACKETS WITH #10 SHEET METAL SCREWS PROVIDED.

4)

SLIDE CUTTING BOARD IN PLACE. EXISTING BRACKETS ON CUTTING BOARD

SHOULD MATE WITH FORMED EDGES ON END SUPPORT BRACKETS.

5)

CUTTING BOARDS 48" AND LONGER ALSO HAVE A CENTER SUPPORT WHICH

ATTACHES ON THE BOTTOM SIDE OF THE PERIMETER FRONT (UNDER THE

"CAUTION HOT" WARNING LABEL) WITH EXISTING 1/4–20 SCREWS.

Perimeter Front

Part No. 055523