1. DL manuals
  2. Kemco
  3. Car Video System
  4. 50-0230B-002
  5. Installation Instructions Manual

Kemco 50-0230B-002 Installation Instructions Manual

Summary of 50-0230B-002

  • Page 1

    Installation instructions for 50-0230b-002 50-0230b-003 50-0230b-004 suburban overhead console with flip down tv these instructions are intended for use only by experienced professionals in the automotive customizing business. Special tools and equipment, as well as specialized handling and care of ...

  • Page 2

    2 materials provided for installation: item description qty 1 screw, # 8 x 3/4" hwh 4 2 screw, # 6 x 1/2" pph 4 3 screw, # 6 x 3/8" pph 4 4 screw, # 8 x 2 1/2" pfh 3 5 screw, #8 x 1 1/4" pwh 2 6 mounting bracket 1 7 console 1 8 light 2 9 light trim 2 10 plywood, 3/8" x 6" x 14" 1 11 screw, 6-32 x 3/...

  • Page 3

    3 i. Preparation of vehicle interior 1. Remove the o.E.M. Console mounted to inner roof of vehicle. Remove and discard (1) one screw from recess in front of console near rear view mirror. Disconnect wire harness and remove console from vehicle. Use care not to damage a/c control head. See figure 1. ...

  • Page 4

    4 6. Carefully trim headliner from the dome light area toward the front of vehicle as shown. See figure 4. Caution: before cutting headliner material, check for wiring or other componentry above headliner. Cut only where indicated. 7. Install the mounting bracket in the o.E.M. Dome light area. Align...

  • Page 5

    5 9. If vehicle is equipped with an electronic compass, unsnap the wire harness clip and relocate toward center of vehicle. See figure 7. 10. Remove and retain the (2) two door scuff plates on driver’s side. See figure 8. 11. Remove and retain the handle which mounts to the top of the “b” pillar. Se...

  • Page 6

    6 13. Measure 7” from rear a/c control opening toward the rear of vehicle. Using a razor knife, carefully cut an opening in the headliner that is 6” wide x 8 3/4” long. Make sure that the 6” width is centered in the vehicle. Caution: before cutting headliner material, check for wiring or other compo...

  • Page 7

    7 19. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: above the headliner from rear a/c...

  • Page 8

    8 25. Raise video system into approximate position and connect all wiring to components. Route video cable through hole in mounting bracket. Connect wiring and cabling to video system per instructions included with video system. Make sure lights in video system operate with door jamb switch. 26. Che...