Kuryakyn Road Thunder Installation Instructions - page 4
PAGE 4
302714
DPF-MRK-003 REV A 6/20/16
ROADTHUNDER SOUND BAR BY MTX, SATIN SILVER
2714
866 277 9598 | INFO@KURYAKYN.COM
454 COUNTY ROAD VV SOMERSET, WI 54025
KURYA KYN.C OM
INSTALLATION INSTRUCTIONS
ELECTRICAL OPERATION
STEP 1
Tap the Power button to turn the unit on. (Power, Ground, and Ignition wire need
to be connected to a 12V power source.)
STEP 2
Tap the Power button to switch modes between Bluetooth and AUX.
STEP 3
Hold the Power button for 2 seconds to turn the unit Off.
STEP 4
The integrated fuse and ring terminals allow for easy wire connection to a 12V
power source.
STEP 5
The remote turn on (blue wire) only operates when the unit is powered on.
Note: The indicator light will illuminate Blue when in Bluetooth mode and Green
when in AUX mode.
OPERATION
FOLLOW THESE STEPS TO UTILIZE THE BLUETOOTH FUNCTIONALITY USING A BLUETOOTH
ENABLED DEVICE:
STEP 1
Power the unit On by tapping the Power button once.
STEP 2
Select Bluetooth by tapping the Power button until it blinks Blue.
STEP 3
Select “MTX Sound Bar” from the menu on your Bluetooth enabled device. The
unit will power on in Bluetooth mode first when it is turned on by tapping. If the
Ignition wire is disconnected, (vehicle is turned off and then turned on) the unit
will revert back to the previous Bluetooth or AUX setting.
STEP 4
Choose “Pair” when prompted.
STEP 5
Once “Paired” the unit will be able to play audio from your Bluetooth device.
The front panel control buttons will control track forward/back and volume up/
down in this mode. The Play/Pause button will mute the output and the LED
indicator will blink Blue when in Mute mode.
FOLLOW THESE STEPS TO UTILIZE BLUETOOTH IN A NFC (NEAR FIELD COMMUNICATION)
ENABLED DEVICE:
STEP 1
Power the unit On by tapping the Power button once.
STEP 2
Select Bluetooth by tapping the Power button until it blinks Blue.
STEP 3
Tap the NFC enabled device on the (left) side of the enclosure (marked by NFC
label).
STEP 4
Choose “Pair” when prompted.
STEP 5
Once “Paired” the unit will be able to play audio from your NFC device.
FOLLOW THESE STEPS TO UTILIZE AN AUXILIARY INPUT DEVICE:
STEP 1
Power the unit On by tapping the Power button once.
STEP 2
Select Auxiliary by tapping the Power button until it blinks Green.
STEP 3
Connect an audio device to the AUX input using the “Green” 3.5mm input on
the side of the unit. The LED will illuminate Green, and will blink Green when in
mute mode.
The front panel control buttons will adjust the Volume up/down in this mode. The
Play/Pause button will mute the audio output and the LED indicator will blink
Green when in Mute mode.
USING THE AUXILIARY OUTPUT. OUTPUT MARKED ON (LEFT) SIDE OF ENCLOSURE.
STEP 1
Auxiliary out is a variable output that allows connection to a secondary audio
device, whether it is an external amplifier connected to speakers or subwoofer.
-CONTINUED-