La Gard 8130 Installation Instructions
To ensure problem free installation and application, please read these instructions thoroughly before installing the 8130 Entry Device
and Lock.
8130 ENTRY DEVICE PARTS
• 8130 Entry Device w/Cable Assembly
• Metric Hardware Kit
•
2 Position Shunt (Jumper)
•
M4-0.7 5.5 mm Diam x 5.5 mm Shoulder Screws (2) (for Standard Mounting Method)
•
M4-0.7 x Phillips Head Screws (2) (for Alternate Mounting Method)
• English Hardware Kit
•
#8-32 .218 Diam x .2 Shoulder Screws (2) (for Standard Mounting Method)
LOCK OPTIONS
Dual-Handed Swing Bolt, Dead Bolt, Spring Bolt or Redundant Mechanical Lock
with one of the following lock codes:
ComboGard
(33E
V2.13)
ComboGard Pro (39E V1.01)
AuditGard (66E LGA V1.20)
TimeGard (TL11 V1.30 and V2.22)
Note: Hardware Kit included with lock.
OPTIONAL ACCESSORIES
• Knob Assembly - P/N 2666 (recommended for use with Dead bolt or Spring bolt locks).
• VisionGard Dial Assembly - P/N 2085 (for use with Redundant Mechanical lock). An entire range of LA GARD dials is available for
alternate dial options.
• Battery or Battery/Alarm Box (recommended if using with Time Delay/TimeLock. Alarm Box is required for use of certain features).
•
Small box: P/N 2788 or 2789
•
Large box: P/N 4001 or 4002
INSTALLATION INSTRUCTIONS
(P/N)738.098 Rev A • 04/09
© copyright 2009
Kaba Mas LLC
page 1 of 5
8130
8130
Electronic Entry Device with Lock
The installation instructions are the basis for Security Agency Approvals. The lock installation must be done in accordance to these
instructions in order to maintain the labeled approval level.
DESIGN PARAMETERS FOR DEAD BOLT LOCKS
1. Bolt dimensions (nominal): .312 inches x 1.000 inches/8 x 25.4mm
2. Bolt movement (nominal): .465 inches/11.8mm
3. Bolt extension: .465 inches/11.8mm
4. Maximum load movable by the bolt: 5 lbs. (22N)
Note: LA GARD dead bolt locks may not open if more than 5 lbs. (22N) of force is applied to the end or side of the bolt.
5. Maximum load against bolt when thrown (all directions): 224.8 lbs. (1kN)
6. The lock can be fi tted to safes or vault doors of any material.
Note: As is the case with all mechanical and electronic locking devices, the container and boltworks must be designed to protect
the lock.
2788 Small Battery Box
2789 Small Alarm/Battery Box
4001 Large Battery Box
4002 Large Alarm/Battery Box
2666 Knob Assembly
(For use with Dead Bolt or Spring Bolt Locks)
2085 VisionGard Assembly
(For use with Redundant
Mechanical Locks)
Dual-Handed
Swing Bolt Lock
Dead bolt Lock or
Spring Bolt Lock
Redundant
Mechanical Lock