MANUAL FOR USE AND MAINTENANCE
LSC 001 -UK- REV. 06
2) Then clean the filter holders and the filters with the brush provided, making sure no dirt is left inside
the filter holders and that all filter holes are clean.
3) Clean the shower heads below the delivery groups with the brush.
4) Clean the drip tray (9) and the cup grid (10), using the standard detergents on sale, if necessary.
EVERY TWO WEEKS
After turning off the machine, remove the shower heads using the wrench provided; brush them carefully,
making sure that all the holes are clean and then refit them following the sequence illustrated in Fig. 3.
Every day, at the end of work and after daily cleaning, turn off the appliance using the electric
switch; then close the water supply tap and the gas tap (if fitted) (Fig.1 – page 6).
Do not use water jets to clean the machine.
If the installation of a water softener has been recommended by the installation engineer because of hard
water and problems of scale deposits, it is necessary to follow the instructions of the water softener’s
manufacturer (periodic regeneration).
Small shower head
Large shower head
Shower head block
HOW TO CLEAN THE MILK – SENSOR
Clean the milk – sensor every day as follows:
1) Unscrew the steamer (1) and dip it in hot water and
Pulicaf detergent for 30 minutes (picture below).