LaCie 130737 - 321 - 21.3" LCD Monitor User Manual

Manual is about: User Manual

Summary of 130737 - 321 - 21.3" LCD Monitor

  • Page 1

    Lacie 321 user’s manual.

  • Page 2

    Warning to prevent fire or shock hazards, do not expose this unit to rain or moisture. Also, do notuse this unit's polarized plug with an extension cord receptacle or other outlets unlessthe prongs can be fully inserted. Refrain from opening the cabinet as there are high voltage components inside. R...

  • Page 3

    Canadian department of communications compliance statement doc: this class b digital apparatus meets all requirements of the canadian interference-causing equipment regulations. C-ul: bears the c-ul mark and is in compliance with canadian safety regulations according to can/csa c22.2 no. 60950. Fcc ...

  • Page 4

    Contents your new lacie 321 monitor box* should contain the following: •lacie 321 monitor with tilt/swivel/pivot/height adjust stand •power cord •video signal cable (15-pin mini d-sub male to dvi-a) •video signal cable (dvi-d to dvi-d cable) •cd-rom •cable cover *remember to save your original box a...

  • Page 5: Quick Start

    English-4 quick start to attach the lacie 321 monitor to your system, follow these instructions: 1. Turn off the power to your computer. 2. For the pc or mac with dvi digital output: connect the dvi signal cable to the connector of the display card in your system (figure a.1). Tighten all screws. Fo...

  • Page 6

    English english-5 figure c.1 figure c.2 figure d.1 figure rl.1 input2 input1 vacation switch power button input2 input1 raise and lower monitor screen the monitor may be raised or lowered in either portrait or landscape mode. To raise or lower screen, place hands on each side of the monitor and lift...

  • Page 7

    English-6 tilt grasp top and bottom sides of the monitor screen with your hands and adjust the tilt as desired (figure ts.1). Figure ts.1 figure s.1 swivel grasp both sides of the monitor screen with your hands and adjust the swivel as desired (figure ts.2). Note: handle with care when tilting the m...

  • Page 8: Controls

    English english-7 controls osm (on-screen manager) control buttons on the front of the monitor function as follows: to access osm menu, press any of the control buttons (exit, , , –, +). To change signal input, press the select button. Note: osm must be closed in order to change signal input. Note: ...

  • Page 9

    English-8 fine (analog input only) improves focus, clarity and image stability by increasing or decreasing this setting. If the “auto adjust function” and the “h.Size” function do not give you a satisfactory picture setting, a fine tuning can be performed using the “fine” function. It improves focus...

  • Page 10

    English english-9 note: depending on the pc and video card used, or when another video signal cable is attached, this function may not operate. Off timer: monitor will automatically power-down when the end user has selected a pre-determined amount of time. Tools 2 language: osm control menus are ava...

  • Page 11: Recommended Use

    English-10 recommended use safety precautions and maintenance for optimum performance, please note the following when setting up and using the lacie 321 colour monitor: • do not open the monitor. There are no user serviceable parts inside and opening or removing covers may expose you to dangerous sh...

  • Page 12

    English english-11 correct placement and adjustment of the monitor can reduce eye, shoulder and neck fatigue. Check the following when you position the monitor: • for optimum performance, allow 20 minutes for warm-up. • adjust the monitor height so that the top of the screen is at or slightly below ...

  • Page 13: Specifications

    English-12 specifications monitor specifications lacie 321 monitor notes lcd module diagonal: 54 cm/21.3 inches active matrix; thin film transistor (tft) liquid viewable image size: 54 cm/21.3 inches crystal display (lcd); 0.270 mm dot pitch; native resolution (pixel count): 1600 x 1200 250 cd/m 2 w...

  • Page 14: Troubleshooting

    English-14 troubleshooting no picture • the signal cable should be completely connected to the display card/computer. • the display card should be completely seated in its slot. • check the vacation switch should be in the on position. • front power switch and computer power switch should be in the ...

  • Page 15: Appendix

    English english-15 appendix if you need detailed information about the controls, please use the advanced menu. • turn off your monitor. • turn on your monitor by pushing the “power” and “select” button at the same time for at least one second simultaneously. • you will see the advanced menu. This me...

  • Page 16

    English-16 auto sw determines the automatic adjustment level for auto adjust. The choices are “simple”, (analog input only) “full” and “detail”. Press “+” or “-” to select. Refer to the below table. Determines the automatic adjustment level as shown in the below table. Tag4 auto automatically adjust...

  • Page 17

    English english-17 tag6 colour control colour control systems: six colour presets select the desired colour setting (srgb, native and programmable colour presets are standard and cannot be changed). Colour temperature increases or decreases, in each preset. R,y,g,c,b,m,s: increases or decreases red,...

  • Page 18

    English-18 osm lock out this control completely locks out access to all osm control functions. When attempting to activate osm controls while in the lock out mode, a screen will appear indicating the osm controls are locked out. There are two types of osm lock out: osm lock out with brightness and c...

  • Page 19: Tco’99

    English english-19 congratulations! You have just purchased a tco’99 approved and labelled product! Your choice has provided you with a product developed for professional use. Your purchase has also contributed to reducing the burden on the environment and also to the further development of environm...

  • Page 20

    Manufacturer’s recycling and energy information lacie group sa is strongly committed to environmental protection and sees recycling as one of the company’s top priorities in trying to minimize the burden placed on the environment. We are engaged in developing environment-friendly products and always...