1. DL manuals
  2. LANCAST
  3. Media Converter
  4. 2111-12-01
  5. Installation & user manual

LANCAST 2111-12-01 Installation & user manual

Manual is about: “twister” 2111 10MBPS MEDIA CONVERTER

Summary of 2111-12-01

  • Page 1

    L a n c a s t ® installation & user guide models: 2111-12-01 / 2111-12-02 / 2111-13-01 / 2111-13-02 / 2111-15-01 2111-15-02 / 2111-16-01 / 2111-16-02 / 2111-18-01 / 2111-18-02 l ancast ® “twister” ™ 2111 10m bps m edia c onverter tx rx mm lk lk at at pwr 10base-fl 10base-t ™ “twister” 2111 ® tx rx s...

  • Page 2

    © 1999 lancast, inc. All rights reserved. Printed in usa. This publication is protected by the copyright laws of the united states and other countries, with all rights reserved. No part of this publication may be reproduced, stored in a retrieval system, translated, transcribed, or transmitted, in a...

  • Page 3: Table of Contents

    Table of contents “twister” 2131 media converter installation & user guide introduction ............................................................................................... 4 overview .................................................................................................... 5 in...

  • Page 4: Introduction

    4 introduction thank you for choosing lancast “twister” media converters. Lancast “twister” media converters represent the hottest technology available for extending ethernet and fast ethernet networks. Since lancast first developed “twister” media conversion, it has become a standard for providing ...

  • Page 5: Overview

    “twister” 2111 media converter 5 overview the lancast “twister” 2111 10mbps media converters provide seamless integration of 10base-t category 3, 4 and 5 twisted-pair with singlemode and multimode 10base-fl fiber optic segments as well as thinnet coax in ethernet environments. To optimize your ether...

  • Page 6

    6.

  • Page 7: Installation Guide

    “twister” 2111 media converter 7 2 installation guide follow the simple steps outlined in this section of the guide to install and start using your lancast “twister” media converter. Unpack the “twister” and any accessories. Check that the following components have been included with your order: • “...

  • Page 8

    8 installation guide set the switches. Link loss carry forward (llcf) switch. * the 2111 media converter incorporates link loss carry forward (llcf) functionality as an aid in troubleshooting a remote connection. A switch for enabling/disabling llcf is located on the rear panel of the converter. Whe...

  • Page 9

    “twister” 2111 media converter 9 mdi- ii to mdi-x switch. All “twister” media converters with twisted-pair ports have an mdi- ii to mdi-x switch that eliminates the need for crossover cables. This switch is located on the bottom of the unit directly below the rj-45 connector and allows simple setup ...

  • Page 10

    10 installation guide connect to the network. The lancast “twister” 2111 media converter offers the ease of plug-and-play installation. Please refer to the appropriate section below for more information and guidelines regarding specific network connections. Twisted-pair connections (all models). The...

  • Page 11

    “twister” 2111 media converter 11 fiber optic connections (2111-13, 2111-15, 2111-16, 2111-18). These “twister” models support 10base-fl segments via st, sma or sc connectors. • the 2111-13-01, -02 provide one set of fl multimode sc connectors and suppport a maximum segment length of up to 2km for r...

  • Page 12

    12 installation guide when making fiber optic connections, be sure that the transmit (tx) port of the “twister” connects to the receive (rx) port of the connected device; and be sure that the transmit (tx) port of the connected device connects to the receive (rx) port of the “twister” unit. Once pow...

  • Page 13

    “twister” 2111 media converter 13 important: the coaxial cable of a lan must be properly terminated at each end regardless of the device used at the end of each cable. A bnc terminator must be attached to each end of each trunk segment. One of the two terminators on each segment must be grounded. Re...

  • Page 14

    14 installation guide 5 apply power. Power is provided to the “twister” unit from the desktop power supply module. This power module is equipped with a s760 hollow-type plug for insertion into the dc jack located on the back of the “twister” unit and standard iec 320-type ac power receptacle. Refer ...

  • Page 15

    “twister” 2111 media converter 15 upon receiving power, the “twister” media converter goes into normal operation mode and automatically provides the appropri- ate signal translation between the connected network segments. Be sure to verify correct segment connectivity via the lk (link) leds on the f...

  • Page 16: User Guide

    16 user guide user guide this section contains more detailed user information regarding certain operating features for your “twister” media converter. System leds the lancast “twister” 2111 media converter provides leds for the visible verification of unit status and proper functionality as well as ...

  • Page 17

    “twister” 2111 media converter 17 management station management station switch/hub w/snmp switch/hub w/snmp “twister” “twister” remote up to 15km led lit = established link led unlit = no link management station management station switch/hub w/snmp switch/hub w/snmp “twister” “twister” broken remote...

  • Page 18

    18 user guide topology solutions f/o links twisted-pair links switch 2km multimode f/o 15km singlemode f/o servers “twister” 2111 “twister” 2111.

  • Page 19

    “twister” 2111 media converter 19 enterprise switch switch 2km multimode f/o “twister” 2111 “twister” 2111 enterprise.

  • Page 20

    20 user guide technical specifications data rate data rate __________________________________ 10mbps half-duplex ___________________________________ 20mbps full-duplex bit delay _____________________________________________ network connections twisted-pair interface connector _______________________...

  • Page 21

    “twister” 2111 media converter 21 power universal input ________________________________ 90-260v ac 50/60 hz output _____________________________________ +5vdc @ 1.2 a domestic input ______________________________________ 115v ac 60 hz output _____________________________________________ 5v dc envir...

  • Page 22

    22 user guide product safety, emc and compliance statements this equipment complies with the following requirements: • ul • csa • en60950 (safety) • fcc part 15, class a • en55022 class a (emissions) • en50082-1 (immunity) • ieee 802.3 • iec 825-1 classification class 1 laser product the following f...

  • Page 23

    “twister” 2111 media converter 23 warranty and servicing limited lifetime warranty for lancast media converters lancast, inc. Warrants that every lancast media converter product purchased after april 30, 1999, will be free from defects in material and workmanship for its lifetime. This warranty cove...

  • Page 24: L A N C A S T

    L a n c a s t ® 12 murphy drive, nashua, nh 03062 usa tel: 603-880-1833 • fax: 603-594-2887 www.Lancast.Com 5660-211112-001 a 6/99.