Land Pride Ditcher DT55 Features And Benefits
Ditchers
Table of Contents
Features and Benefits
Designs, specifications, features and information are subject to change without notice.
29
DT55 & DTM55 Series
Features
Benefits
HP range
70 - 120 HP
Cat. 2 & 3
Fits wide variety of tractors.
Quick-Hitch adaptable
Quickly and easily attach tiller to tractor with one person.
Formed tubing hitch
Formed tubing with 1/4” wall offers greater strength vs. plate steel hitch.
540 & 1000 rpm models
Allows fitting larger tractors that are 1000 rpm only. Driveline available in 1 3/8” or 1 3/4”.
20” Impeller
20” Impeller digs a nice size drainage or irrigation ditch up to 10" deep with each pass.
6 Blades on impeller
6 Blades make digging easier and smoother than fewer blades.
3/8” Hardened blades
Heavy-duty blades made out of AR400 material for long life.
Blades can be rotated when
worn and are replaceable.
Each blade has four cutting edges to extend blade life. When one edge is worn, rotate
blade 90
o
to a new cutting edge. Replace blades when all four cutting edges are worn out.
3/8” Hardened cutting edge
Impeller blades feature a replaceable hardened edge to take on rough and rocky
conditions. Easier and more cost effective to replace edge vs. using hard faced material on
impeller.
Double 80 chain
Double 80, high tensile roller chain keeps stretching to a minimum and has the strength
needed to take shock loads posed by extreme digging conditions.
Spring loaded chain idler
Chain idler is spring loaded to keep constant tension on chain during tough digging
conditions, which also makes for smoother digging operations.
Hardened tooth sprockets
Hardened tooth sprockets have the strength needed to take the load of the double 80 chain
and rigorous digging conditions.
2 Greasable flange bearings
Input and output shafts feature 2 1/4” ID ball type bearings. Ball bearings offer smooth and
quiet operation. Bearings are greasable to keep properly lubricated and purge dirt out.
4-Bolt cast iron flanges
Bearings are housed in a heavy-duty 4-bolt cast iron flange. Heavy-duty casting offers full
protection under extreme use.
Cat. 5 Shear-bolt driveline
Heavy-duty driveline with shear-bolt protects the unit when obstructions are encountered.
Depth controlling skid shoe
(optional)
Replaceable 3/8” thick skid shoe for long life and uniform depth control.
Material control chute
(optional)
Material control chute allows the operator to place material just outside the tractor path, or
as far away as the tiller will throw it. Control the throwing distance by raising or lowering the
chute with either a 2” x 8” hydraulic cylinder or ratchet jack.
Depth control wheel (optional)
16.5 x 6.50-8 Pneumatic gauge wheel keeps digging depth constant from just skimming
the ground to 10” deep.
Ripper shank (optional)
For hard packed soils, the Shank rips up the ground just ahead of the impeller, allowing the
impeller to take in the soil vs. bouncing on hard packed soil. Shank has 3 height
adjustments from cutting edge depth to 5” below cutting edge.
Ditchers
324-053F
6/22/11