Lanier R/C MARINER 40 MK II ARF Assembly Instructions Manual

Manual is about: Stinger II .46 ARF

Summary of MARINER 40 MK II ARF

  • Page 1

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 1 wingspan.... 62” wing loading… 21-23 oz./sq. Ft. Fuselage length… 48” wing area… 687 sq. In. Engine required ... 2-stroke .40 to .50 weight……....

  • Page 2: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 2 introduction congratulations and thank you for purchasing the lanier mariner 40. We are sure you will be happy with the quality of this kit an...

  • Page 3: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 3 4. Locate the servo mounting plate and remove the covering over the slot with a micro tip soldering iron. Not only does this remove the coveri...

  • Page 4: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 4 7. You will need two 6” servo lead extension for this next step. (not supplied), one for each wing. The extensions must be compatible with you...

  • Page 5: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 5 far side. Now fasten in place with the hardware supplied. 11. Temporarily plug the servo into the receiver. Turn on the radio and allow the se...

  • Page 6: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 6 17. Secure the float assembly in place with the hardware shown. Be sure to place the metal straps at an angle for secure mounting of screw. 18...

  • Page 7: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 7 21. Lay it on the wing. Trace around it and remove the covering inside the line. Remove ink line with paper towel and alcohol. Glue in place w...

  • Page 8: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 8 4. Turn the fuselage over and mark the outline on the bottom of the stab with felt tip pen 5. Remove the covering between the lines. 6. Lay th...

  • Page 9: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 9 hinging the elevator and rudder 1. Before hinging the elevator and rudder to the stab and vertical fin, locate the control horns and ca them i...

  • Page 10: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 10 installing servos and pushrods 1. The servo rails are pre-installed in the fuse. 2. Install the rudder and elevator servo using the hardware ...

  • Page 11: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 11 7. Install the pushrod support on the sleeves temporarily for alignment with the servos. Do not glue in place yet. 8. Plug the servos into th...

  • Page 12: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 12 1. Locate the engine pod with mast. Find the center of the firewall by drawing lines from each corner. Now strike a horizontal and vertical l...

  • Page 13: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 13 cowl installation 1. Unpack the cowl and cutout the opening for the engine as shown in the photo. Make it large enough so you can access the ...

  • Page 14: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 14 5. Drill four 1/16” dia. Holes, two on each side. Use a hand drill however a drill press will ensure straighter holes. Do both sides. 6. Inst...

  • Page 15: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 15 end so fuel line will not be cut. Make sure inside of tank is clean before installing stopper on tank. 2. Wrap fuel tank with bubble wrap (no...

  • Page 16: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 16 6. Remove the engine from the mount. Install the cowl and align the spinner back plate with the cowl leaving 1/16” to 3/32” clearance between...

  • Page 17: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 17 3. Trial fit the wing on the fuselage. The leading edge should fit snug against the front former. It may be necessary to increase the notch d...

  • Page 18: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 18 smooth. Be sure to cut out the notch for the mast, located in the center. 2. Trial fit the windshield on the fuselage. It may necessary to do...

  • Page 19: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 19 balance point forward it may improve the smoothness and tracking, but your mariner may require more speed for takeoff and become more difficu...

  • Page 20: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 20 which in turn will cause your engine to get hot or quit. Charge the batteries 1. Follow the battery charging procedure recommended in the rad...

  • Page 21: Mariner 40 Mk II Arf

    Assembly instructions lanier r/c mariner 40 mk ii arf lanier r/c, inc.- p o box 458 - oakwood, ga 30566 - ph 770-532-6401 © copyright 2006 lanier r/c, inc. 21 we hope you enjoy the mariner as much as we did bringing it to you. Flying off the water is different. And different is what keeps us interes...