Larin TGL-500 Owner's Manual - Assembly Instructions
6
ASSEMBLY INSTRUCTIONS
10 Install the Limit Switch
Use a straight bladed screwdriver to remove the two screws and washers
in the location shown by the arrows. The Limit Switch assembly is packed in
a carton with the pistol-grip trigger, some cables and connectors.
The Limit Switch has a round yellow connector on the end.
Install it as shown using the two screws and washers removed earlier in this
step. Notice that the Limit Switch has slotted holes. These will allow movement
so that you may adjust the maximum lift height for your truck.
To adjust the limit switch, either move the Limit Switch Assembly in the slots,
or remove and rotate the roller control arm, or both. The switch is adjusted at the
time of installation to the truck.
The Limit Switch viewed from the other side..………………………..……….
It is now time to install the unit to your truck. Having an assistant
available will make the next step easier.
INSTALLATION INSTRUCTIONS
11 Install the Lift to the Truck
With the help of your assistant, install the Hitch Adapter Plate tube into
The receiver tube of your hitch. Install a ½” hitch pin (not supplied) through
the holes. In order to connect the cable from the Motorized Cable Module to
the Lifting Arm, it will be necessary to supply power. The Deck Plate will be on
the ground at this time. Lower the inner tubes of the Outrigger Assemblies
so they are near the ground, but not yet touching. Turn the inner shafts to
bring them into contact with the ground. It is not necessary to use the supplied
wrench to turn these shafts, you do not want any pressure now, only contact.