Laser SPK-S20 User Manual

WARNING:

Do not expose speakers to direct sunlight for 

extended periods.

Do not use speakers in extremely hot, dusty, 

humid or damp conditions.

Do not attempt to disassemble these speakers. 

There are no user serviceable parts inside.

Opening these speakers may void your warranty.

For technical support please visit

http://www.laserco.com.au

SPECIFICATION

Total Output Power: RMS 1W

> RMS 0.5W Per Channel

> 2” Full Range Speaker Driver

> Frequency Response: 150Hz~18KHz

> Magnetically Shielded

> Power Indicator

> Dimension: 60(W) x 85(D) x 133(H)mm

OPERATING METHOD

USB connecting cable

LED

NOTE:

The power LED will light when connected to an active USB port.

The LED will flicker when the speakers are recieving an audio signal.

TROUBLE SHOOTING:

Device not recognised:

Confirm that the operating system has native drivers for USB Audio 

devices.

Audio will stop at full volume:

Ensure that the USB port used to connect the speakers is not 

overloaded. Move connection to other ports or connect using a 

powered USB hub.

OPERATING METHOD

NOTE:

In some cases Win98SE or ME can 

not detect USB audio devices

and switch to them.

If the operating system does not

detect the USB speakers, 

please open the “Control Panel”, 

select “Sound and Audio Devices”. 

Choose the “Audio” page and then 

change the “Default Device” to 

“USB Device” or “C-Media USB

Device”

1: Plug the USB cable in a spare USB socket on your computer.

2: In the first instance the operating system should detect the 

    speaker and automatically load the correct drivers. 

3: Adjust the volume to the desired level. 

SYSTEM CONNECTION

CONNECTING METHOD

User Manual

SPK-S20

Please read carefully before use