Lava Electronics RVHD-2015 Installation Instructions

AM:520-1719KHz FM:47-230MHz 

UHF: 470-862MHz 

Gain: 30dB

Tech Support: 909-235-6611

LAVA Electronics Inc.                    E-mail:support@lavasat.com

www.lavasat.com

RVHD-2015

OMNIPRO series

Power Supply: DC 12V==50mA

Step 1: Decide location of power supply before mounting your antenna. Antenna 

and power supply location will determine where and how you run the cables. DO 

NOT install the antenna before you read this instruction.

Step 2: Drill a hole thru the roof to run cable from the antenna into your vehicle. Or 

if your vehicle have a cable hole already, run the cable thru hole to the antenna.

Step 3: Using 4 self-tapping screw to securely fasten antenna mount to the roof. Do 

not over tighten the mounting bolts, damage to the mounting stand or roof may 

occur.

Step 4: Use cable tool to drive the cable into the mounting bracket on the 

underside of the antenna, aligning the end of the connector with the F connector 

on the antenna. Turn cable tool until the connector is tight and remove the cable 

tool.

Step 5: After cable connector is made, slide antenna onto the mount. Gently pull 

back any extra cable inside vehicle.

Step 6: Fasten antenna to mount using self-tapping screw and hex nuts. Tighten 

firmly to prevent antenna from turning on mount or mast.

Step 7: Connect power supply MP-002 kits (not included in this package)