Le Cappe ISLAND MOUNT HOODS Instructions Manual And User Manual

Manual is about: Hoods

Summary of ISLAND MOUNT HOODS

  • Page 1

    Instructions guide and user 's manual island mount hoods important: read and save these instructions. Notice: installer: leave this guide with the homeowner homeowner: keep this guide for future reference.

  • Page 2: Important Safety Notice

    Important safety notice installing and o perating this a ppliance read and save these instructions. Installer, leave this guide with the homeowner. Keep this guide handy for future reference. Important safety instructions warning – to reduce the risk of fire, electric shock or injury to persons, obs...

  • Page 3

    • 2 cappe international inc. 2014 warning – to reduce the risk of fire, electric shock, or injury to persons, observe the following: a) no special skills are required to install this appliance. Yet, if any installation work and/or electrical wiring are necessary, it must be done by qualified person(...

  • Page 4: Table of Content

    Table of content tools needed: installation 3 4 5 5-6 7 8 9 tools needed. Parts supplied. Venting requirements. Mount heights & clearance. Venting methods . Electrical requierements . Preparations . Installation . 10 use and care 11-12-13 14 15 range hood operations . Troubleshooting. Use and care i...

  • Page 5: Parts Supplied:

    Parts supplied: range hood (vary by model) lower standard chimney upper standard chimney a qty: 4pcs b qty: 10pcs c qty: 10pcs f qty: 2pcs hex key qty: 1 pcs (optional with glass canopy) d qty: 8pcs e qty: 12pcs glass canopy screw qty: 4 pcs 4 (optional with re-circulat- ing kit. Pre-installed when ...

  • Page 6: Venting Requirements

    Venting requirements height & clearance • vent system must be set to exhaust outdoors either through the roof or sidewall. • do not set the vent system through the an at tic or any other enclosed area. • do not use 4” (10.2 cm) laundry-type wall caps. • use metal / aluminum vent s only. A r igid all...

  • Page 7: Important

    Important • a 6” round (standard for this range hood) or 3-1/4 x 10” rectangular duct (purchased sepa- rately) must be used to maintain maximum airflow efficiency. • a lways use rigid type metal/aluminum ducts , if available , to maximize airflow . • refer to the duct run calculation method describe...

  • Page 8

    Re-circulating function methods: venting methods: this range hood is factory set for venting through the roof or wall. That is, vent work can run either through the roof or a side wall, whereas to vent through a wall, a 90° elbow is needed. Important: • never exhaust air or run duct work into spaces...

  • Page 9

    Preparations note: to avoid damage to your hood, prevent debris from entering the vent opening. 1. Carefully remove the white plastic protective coat from the chimney covers and range hood 2. Determine and mark the center line on the ceiling where the range hood will be installed. Make sure there is...

  • Page 10: Installation

    Installation • vent system must terminate to the outside (roof or side wall). • do not terminate the vent system in an at- tic or other enclosed area. • do not use 4” (10.2 cm) laundry-type wall caps. • use metal /aluminum vent only. Rigid metal (not included). Aluminum vent is recommended. • do not...

  • Page 11: Installation

    Installation 9. Have a third person raise up and hold the island range hood in position, connect power plug to the 12” hanging electrical cord, and connect the duct work to the range hood. 10. Mount the hood to the lower support frame using four “d” bolts and four “e” nuts: securely fasten two “e” n...

  • Page 12

    Control panel layout and buttons configurations for models: grecia, paris, venice pro. Range hood opeations & controls range hood operations controls 11.

  • Page 13

    Control panel layout and buttons configurations for models: moon & viena. Range hood operations controls 12.

  • Page 14

    Control panel layout and buttons configurations for models: messina & athenas (see your specific model) range hood operations controls 13.

  • Page 15: Troubleshooting

    Troubleshooting 1. If the range hood or halogen light does not operate after installation: 2. The range hood vibrates when the blower is on: 3. The blower or fan seems weak: 4. The lights work but the blower is not spinning at all, is stuck or is rattling. 5. The hood is not venting out properly: • ...

  • Page 16: Use and Care Information

    Use and care information specifications read and understand the instructions and warnings in this manual before operating the unit save these instructions for future reference. • always leave safety grills and filters in place. Without these components, blo wers could suction hair and loose clothing...

  • Page 17: Specifications

    Specifications for optimal operation, clean range hood and baffle , spacer , filter , grease tunnel , and oil container regularly. Regular care will help preserv ing the appearance of the range hood. Cleaning exterior s urfaces: • clean periodically with hot soapy water and clean cotton cloth. Do no...

  • Page 18: Changing The Light Bulb

    Cleaning aluminum grease filter / stainless steel filter less grill changing the light bulb warning • failure to observe the instructions on cleaning the unit and changing the filters could cause a fire hazard. You are therefore strongly recommended to follow these instructions. • the manufacturer s...

  • Page 19

    Le cappe one year limited warranty: please provide an original dated proof of purchase (sales receipt / invoice) in order to obtain service under warranty. One year parts warranty: for one year from the date of original purchase, your local reseller will provide , free of charge, non- consumable rep...