MacNeil Pet Barrier Instruction Manual

When the Pet Barrier is

adjusted to your satisfac-

tion, lock your adjustments

in place by installing the 4

Screws (H). Thread the

Screws through the thin

wall portion of the Plastic

Vertical Brackets (B).

Tighten firmly with your

phillips-head screwdriver.

STEP 5a

Center the assembled Pet Barrier in your vehicle with

the Threaded Rod Assembly portion on the floor and

extend it vertically until it is expanded snugly against the

roof and floor of the vehicle. Be sure the Vertical Tubes

are perpendicular to the floor. To secure the position,

turn the wing nuts until they are snug against the

Vertical Upright Tubes.

STEP 5b

Once the barrier is firmly installed, you can optimize the func-

tion of your Pet Barrier by adjusting the Telescoping Hoop

Assemblies (A). First adjust the Telescoping Hoop

Assemblies by pushing or pulling them horizontally. Then you

can vertically optimize the position.

STEP 5a

STEP 5b

Instruction Manual

Pet Barrier

Pet Barrier

N O T E S

• This product is not to be used as a cargo barrier.

Any use of this product for that reason voids

warranty and releases manufacturer of any and

all liabilty.

• WeatherTech

®

also offers the MW12N, an exten-

sion for the WeatherTech

®

Pet Barrier, to add

height to vehicles with larger vertical cargo area.

• Check the Wing Nuts on the Vertical Tubes

periodically to adjust for settling.

6

5

P e t   B a r r i e r