Magicar M100AS User Manual - page 19
Set-up and Other Functions
Setting the Shock Sensor Sensitivity
Entering Valet Mode Using a Key
38
Controlling Shock Sensor Sensitivity
To adjust the shock sensor sensitivity, locate t he shock
sensor and adjust the dial on t he sensor. The higher the
number on t he dial, the higher the sensitivity of the
sensor.
※Shock Sensor sensitivity can vary from vehicle to
vehi cle for many reasons including where and how it
is m ounted, and the size of the vehicle. Some after
install adjustment may be necessary to fine tune the
s e n s o r .
Control of Siren Sound
In order to increase the vol ume of t he siren, locate
the siren, (usually under t he hood in the engine bay)
and cut t he loop of black wire at the base of the siren.
Be careful not to cut the thicker black ground wire of
the siren.
If the remote has been lost or damaged, you can enter Valet Mode
using t he ignition key of the vehicle. The following steps must be
compl et ed wi thi n a li mi ted am ount of ti me, so please read
through the instructions before beginning.
1. Turn the key to the
“Ignition On”position. When the ignition
is on, the lights in the instrument cluster wi ll turn on. In most
vehicles this position is two
“c l i c k s”forward from the “O f f”
p o s i t i o n .
2. Move the key back one
“c l i c k”to the “Accessory On”p o s it i o n .
The lights in the instrument cluster should turn off.
3. Steps 1 and 2 must be repeated for a total of three times within
three seconds. Once t his has been done, the alarm will turn off
and valet mode will be active
(Ke y Bo x)
<
The higher the numbers,
the more sensiti ve
>
Valet Mode can only be turned off through the remote
(Press buttons
I + I I I
for 0.5 sec. at the same time, the siren wil l chirp and the
parking lights will flash twi ce.)
37
Number of Flashes
O n c e
T w i c e
3 times
4 times
5 times
Error Explanation
Engine is already running.
Igni tion (Key) is on.
Door open.
Trunk open.
Reservation Mode not set.
(Manual transmission vehicles only.)
If there is a problem remote starting your vehicle, you will hear t hree chirps from
the remote to indicate that there is a problem. If you go to the vehicle and try again,
an error code will be displ ayed through the parking lights. The li ght s wil l flash
three times, pause, and then flash a number of times equivalent t o the error code
number. Example for error code 4, the parking li ghts wi ll flash t hree tim es, pause,
and then flash four times.
Examination of Remote Wakeup Failure
Set-up and Other Functions
Reservation Mode Cancellation in Manual Transmission Vehicles
After Reservation Mode has been set up, it will be cancelled if either the t runk or a
door is opened.
After driving and removing Key, the engine will stay running for 2 minutes. If but
ton
I I
is pressed for more than 2 sec. during this ti me, Reservation Mode will be
cancelled.
If Valet Mode is ON, Reservation Mode will be cancelled.
Remote Wakeup Reservation
●
On the slopes, a car may move. You should not set up
t he reservation mode.
Warning!