Magicar M100AS User Manual - page 8
1. Extension of Remote Start Timer
During the running time, if you press button I for 2 sec.
“Start-Again”
will scroll across the screen once and the timer will be reset to the preset time.
2. Remote Start Display
If the remote start confi rmation is not received by the remote for different reasons,
pressing any button within range of the vehicle will update the remote and show the
remaining run time.
16
♬♪~Beeps three times after resetting the runtime.
The remaining
runtime will be
reset.
♬♪~Beeps three times after resetting the runtime.
Flashes 5 times
15
Button Functions
Remote Start (ON/OFF)
The vehicle will start and run for a preset time if button II is pressed for 2 sec. If
the vehicle is a diesel, the system will pause for a moment after turning on the igni-
tion to allow time to glow plug warm-up. (If needed.)
●
Vehi cle will be arm ed (if unarm ed before start ) by getting the signal from remote.
●
If t he vehicl e fails to start, a second and t hi rd attempt will be made.
●
Remote Start will run for the preset ti me (10, 25, 3, 5min.). If button II is
pressed again for 2 sec. Remote Start wi ll shut off.
●
The rem ote start running wi ll continue for 20sec aft er a door opens. The car key
needs to be in On position within the 20 seconds.
●
After the vehicle has been remote started, the remaining run-time will be displayed
on the screen.
●
If t he timer goes 1 minute, the remote wil l warn your with (beep) that the vehicle is
about to shut off.
♬♪~Beeps three times
The remaining
time is 9min.
and 50 sec.
●
Remote starting should be avoided while people are i nside
the vehicle.
●
You will need to turn the key to the ON position in order to
drive the vehicle. Turning the key past the ON position
could cause damage to the vehicle starter.
Caution!