National Wheel-O-Vator Destiny Owner's Manual - page 5
1. Do not attempt to enter hoistway or service components yourself. Call your authorized installation dealer
for professional assistance.
2. Do not use harsh chemicals or flammable products for cleaning elevator surfaces or equipment controls.
3. Depending on cab finishes, mild cleaning agents or polishes should keep your Destiny looking like new.
4. This is a passenger elevator. Do not exceed the weight capacity or use it for unintended purposes.
For example: heavy furniture or freight.
5. Under no circumstances should you attempt to by-pass safety features such as, but not limited to: door
locks, gate switches, pit or top of car safety switches, slack rope safeties. They are installed to comply
with codes and protect you from personal injury.
Maintenance and Precautions:
Number
of Flashes
Problem
Solution
1
Safety Chain Fault
The main safety chain is open.
Call dealer for service.
2
Gate/Stop Switch Fault
A call was placed for 10 seconds but the car gate showed to
be open or the in car stop switch showed to be activated.
Make sure the car gate is closed and
the in car stop switch is not activated.
3
Door Lock Fault
The hoistway door lock was either opened during travel or the
lock contacts did not make up before the elevator left the door
zone.
Make sure the door is fully closed
allowing the door to lock.
4
Door Close Fault
A call was placed for 10 seconds but the hoistway door
showed to be open.
Make sure that all hoistway
doors are closed.
5
Upper Terminal Limit Fault
Upper terminal limit activated.
Call dealer for service.
6
Lower Terminal Limit Fault
Lower terminal limit activated.
Call dealer for service.
7
Fault Contact
Run or up contactor failed to release, the door closed, or gate
E-stop inputs failed.
Call dealer for service.
8
Up Run Timer
Timed out while running up. (Low Oil)
Call dealer for service.
9
Down Run Timer
Timed out while running down.
Call dealer for service.
10
Battery Lowering Mode
A call was placed to an upper floor, however the elevator
could not respond because it is battery lowering mode.
Check the power source to the elevator.
11
Sensor Fault
Any failed sensor could initiate this error. This error will also
occur if the unit passes or stops at a floor and the sensor com-
bination is showing that it is not the anticipated floor.
Call dealer for service
Diagnostic Codes are displayed through the call buttons. The code is displayed immediately after the prob-
lem occurs. To review the current diagnostic code, press and hold the call for 2 seconds and release.
5