NATURA NWSB SER.4 Installation And Maintenance Manual

Manual is about: Aquarius Series WATER DISPENSER, REMOTE CHILLER

Summary of NWSB SER.4

  • Page 1

    Installation and maintenance guide for: natura water llc. 222 east campus view blvd columbus, ohio 43235 u.S.A. Natura model nwsb ser.4 countertop water dispenser (aquarius series) natura model nwsbu2 ser.4 remote chiller (aquarius series).

  • Page 2

    1 installation and maintenance manual index 1. Product specifications 2. Important requirements 3. Safety warnings 4. Directions for proper placement of the components 5. Proper quick connect fitting connection instructions 6. Counter top model schematic 7. Water inlet/filtration installation 8. Wat...

  • Page 3

    2 installation and maintenance manual 1. Product specifications: dimensions: length 19.0” length with drip tray 24.5” width 12.5” height 17.9” height with taps 19.9” weight - empty 65 lbs weight - with water 100 lbs refrigerant: 3.2 ounces, r-134a input voltage: 115 vac, 60 hz, single phase amperage...

  • Page 4

    3 installation and maintenance manual o use only original and new parts to guarantee the reliability, optimization, and performance of the natura water machine. O always wear proper protection when performing any type of service or maintenance. O do not expose the co 2 cylinder to direct sun light, ...

  • Page 5

    4 installation and maintenance manual 4. Directions for proper placement of the components: o place the unit in an appropriate location, far from heat sources and with adequate ventilation, on a fl at level surface. The surface must be able to support the 100 lb weight of the unit. O locate the unit...

  • Page 6

    5 installation and maintenance manual 5. Proper quick connect fitting connection instructions: plastic tubing quick-connect fittings connections between the pressure regulator, filtration unit and water refrigeration unit are accomplished using plastic tubing and push-together quick-connect type fi ...

  • Page 7

    6 installation and maintenance manual 6. Counter top model schematic: water inlet/filtration system refrigeration/carbonation system co 2 supply system note: ground fault circuit interrupter (gfci) outlet recommended. Note: co 2 cylinder supplied by customer ( 10-15-20 lbs) customer supplied valve n...

  • Page 8

    7 installation and maintenance manual 7. Water inlet/filtration installation: 1 2 3 4 5 10 8 8 7 11 6 9 adapter fitting water pressure regulator filter set 3/8” o.D. Water line water leak protection device (water block) water shut-off valve wall mount bracket braided hose 1. Connect the components i...

  • Page 9

    8 installation and maintenance manual 8. Water inlet/filtration installation: step 1 1 2 3 4 5 water leak protection device (water block) braided hose 1. Connect the components in order as shown above. Additional assembly / adjustment will be required for the water leak protection device. This is de...

  • Page 10

    9 installation and maintenance manual 9. Water inlet/filtration installation / filter installation: step 2 3/8” elbow 3/8” elbow 10 9 filter set filter manifold pre-sediment filter (inlet side) carbon filter nanoceram® (outlet side) warning: do not use with water that is not microbiologically safe o...

  • Page 11

    10 installation and maintenance manual 10. Water inlet/filtration installation: step 3 11. Water inlet/filtration installation: step 4 adapter fittings water pressure regulator water shut-off valve water shut-off valve 7 7 8 8 4 1. Connect the components in order as shown above. 2. Connect 3/8” o.D....

  • Page 12

    11 installation and maintenance manual 12. Co 2 supply system installation: 1. Use only food grade co 2 (un1013). 2. Place the co 2 cylinder within 5 feet of the countertop water dispenser or remote chiller. 3. Use a small chain or strap to secure the co 2 cylinder to a secure support. 4. To ensure ...

  • Page 13

    12 installation and maintenance manual 13. Counter top model installation: 1. Connect the 3/8” o.D. Water tube from the exit port of the filter set into the 3/8” elbow fitting at the rear of the unit. 2. Connect the 1/4” o.D. Co 2 tube from the co 2 cylinder pressure regulator to the 1/4” elbow fitt...

  • Page 14

    13 installation and maintenance manual 14. Counter top model tap installation: 1. Locate the two taps. They are in the top pad of the packaging. 2. Starting on the left, install the carbonated water tap with flow adjustment. 3. Place the tap into the front panel fi tting. Ensure the tap is aligned v...

  • Page 15

    14 installation and maintenance manual 15. Remote chiller model shank assembly: water dispense system 1 4 2 5 3 6 shank shank washer shank fitting 3/8” x 5/16” reducing elbow locking clip shank adapter nut 1. Assemble the shank washer, shank fitting, shank adapter nut, locking clip, and reducing elb...

  • Page 16

    15 installation and maintenance manual 16. Remote chiller model installation: 1 2 3 carbonated water tap still water tap dispense tower 4 5 8 6 remote chiller model from co 2 cylinder from filter set 5/16” o.D. Tubing 5/16” union fitting 1/4” x 5/16” reducing fitting or 5/16” union fitting 7 remote ...

  • Page 17

    16 installation and maintenance manual remote chiller model installation- connection of the still water tubing. 1. Insert the 5/16” o.D. Tubing into the tubing insulation provided. 2. Connect the 5/16” o.D. Tubing to the right elbow quick connect fi tting on the front of the unit. 3. Connect the oth...

  • Page 18

    17 installation and maintenance manual 17. Flow compensator adjustment ( for remote chiller model only ) 18. Water leak protection device adjustment water inlet from main water source. External reset trigger push to reset. Water outlet to water shutoff valve. Water leak protection device must be ins...

  • Page 19

    18 installation and maintenance manual the water leak protection device is an overfl ow safety device that controls the maximum consumption of water between 5 and 50 liters. Its function is to measure the volume of water that passes through it. If this volume exceeds the set value, the water leak pr...

  • Page 20

    19 installation and maintenance manual 19. Startup procedure: 1. Remove the two lid screws and the lid to access the inside of the unit. 2. Make sure that all of the water and co 2 connections have been made. 3. Open the water shut off valve and check the system for leaks. 4. Open the pressure relief...

  • Page 21

    20 installation and maintenance manual counter top model fill to this level 7. Fill the insulated reservoir with distilled or de-ionized water. Have 5 gallons available. Fill to the level shown. Carefully fi ll until the water level is just below the condensation overfl ow outlet. 8. Replace the top...

  • Page 22

    21 installation and maintenance manual 20. Drip tray placement: the drip tray supplied with your natura product is designed to collect condensation that accumulates during normal operation of the unit. The condensation outlet is located on the bottom of the machine about 1 inch from the front right ...

  • Page 23

    22 installation and maintenance manual 21. Filter replacement: 1. The filters should be replaced every 6 months or before 10,000 gallons of water usage. 2. Turn off the main water supply and disconnect the power from the unit. 3. Open the still water faucet (right side faucet) to release water pressu...

  • Page 24

    23 installation and maintenance manual 1. Unplug the electric power connection, and shut off the water supply and co 2 supply during maintenance or malfunction of the unit. 2. The faucets and nozzles of the counter top unit should be wiped off on a daily basis with a clean cotton rag or non-abrasive s...

  • Page 25

    24 installation and maintenance manual 23. Spare parts drawing - model nwsb ser.4 item part no. Description 1 029191-004 fuse, 1.25a 2 034949p999 pressure relief valve 3 035545-004 condenser fan 4 036247-016 plastic lid 5 036287-013 drip tray grill 6 036289-012 drip tray 7 036311-201 still water tap...

  • Page 26

    25 installation and maintenance manual item part no. Description 1 029191-004 fuse, 1.25a 2 034949p999 pressure relief valve 3 035545-004 condenser fan 4 036247-016 plastic lid 5 036311-207 still water shank assy. 6 036311-208 co2 compensated shank assy. 7 036387-003 backflow preventer 8 036535-004 ...

  • Page 27

    26 installation and maintenance manual problem possible cause suggestion unit not working. - no power. - check the power outlet, plug connection, and the circuit breaker. Power switch is “on”. The refrigeration system is working but the agitator has stopped. - the agitator motor has failed. - replac...

  • Page 28

    27 installation and maintenance manual problem possible cause suggestion the water has an unusual taste. - filters clogged. - co 2 used was not for drinking water. - incoming water quality - replace filters. - check the type of co 2 (un 1013). If necessary, change the tank. - clean & sanitize the fa...

  • Page 29

    Natura water llc. 222 east campus view blvd columbus, ohio 43235 1-877-302-8638 www.Naturawater.Com for technical support, contact the technical service department, distributor or vendor of the unit. Or you may contact: technical assistance and maintenance 26. Contact information: 036333-013 rev. C ...