Content a. General introduction b. Application c. Features include d. Safety instructions e. Front view main functions f. Rear view main functions g. Pre-installation information h. Electrical requirements i. Installation requirements j. Connection and testing k. Operation l. Green power adjustment ...
-1- a. General introduction we are experts in compact high and low frequency power inverters. Our engineers are making use of advanced high frequency design that results in an inverter that is smaller, lighter, and easier to use than any other inverter with similar power ratings. We have been develo...
-2- • do not expose the inverter to rain, snow, spray, bilge or dust. • to reduce risk of hazard, do not cover or obstruct the ventilation openings. • do not install the inverter in a zero-clearance compartment. Overheating may result. • to avoid a risk of fire and electronic shock, make sure that e...
-3- 1. On / off switch: power on/off switch, leave in the off position during installation. 2. Led indication: over volt: over voltage protection. Over temp: over temperature protection. Under volt: under voltage protection. Over load: over load protection. Power: power on. Run/green power: indicate...
-4- g. Pre-installation information: before installing your inverter, please make sure that you have appropriately- sized batteries. A battery that is too small will not allow the inverter to perform to its full specification. H. Electrical requirements dc input voltage of the inverter must be the s...
-5- ac utility source. The ac output ground wire should go to the grounding point for your loads ( for example, a distribution panel ground bus ). 3. Neutral grounding: 120v models: the neutral conductor of the ac output circuit of the inverter is automatically connected to the safety ground during ...
-6- gfci protection of certain receptacles in residential installations. While the output of the inverter is equivalent to the waveform provided by utilities, compliance with ul standards requires us to test and recommend specific gfci’s. State power has tested the following gfci-protected 15a recep...
-7- 3. Before proceeding further, carefully check that cable you have just connected the positive terminal of inverter to the positive terminal of the power source. 4. Connect the cable securely from the negative terminal of inverter to the negative terminal of the power source. 5. Set the power swi...
-8- k. Operation: to operate the power inverter, turn it on using the on/off switch on the front panel. The power inverter is now ready to deliver ac power to your loads. If you are operating several loads from the power inverter, turn them on separately after the inverter has been turned on. This w...
-9- keep the inverter on all the time: this could be used if you have a very small load that must stay on at all times. • adjust the pot until the lamp is steady green, then turn the pot back a little until the lamp flashes green. Allow 10 seconds between adjustments for stabilization: clockwise is ...
-10- • do not operate high power loads with the power inverter while watching television. • make sure that the antenna feeding your television provides an adequate (“snow free”) signal and that you are using good quality cable between the antenna and the television. • move the television as far away...
-11- o. Specifications 0150 watt 0350 watt 0650 watt 1000 watt 1200 watt 1800 watt 3000 watt dc to ac inverter input 12 vdc 24 vdc 48 vdc output 1 – 110 v 2 – 220 v type a – n. American b – u.K. C – australia d – europe e – universal pm-0150l-12 1 e.
