Navtex NVX-1000 Safety & Operating Instructions Manual - -Assembly Instructions-

Manual is about: 10.2” DIGITAL HANDSFREE COLOR MONITOR

Summary of NVX-1000

  • Page 1

    Page 1 these instructions are for your safety. Please read through them thoroughly before use and retain for future reference- before you start check pack and make sure you have all of the part listed above. If not, contact your local store who will be able to help you. Parts description fittings su...

  • Page 2: Technical Characteristics

    Page 2 technical characteristics safety instructions 1. Do not install near other electronic equipment such as computers, tv, video recorder as this may cause radiated interference to the unit. 2. Do not disassemble the unit. 3. Do not spray water on the indoor unit. Do not keep the outdoor unit whe...

  • Page 3

    Page 3 indoor unit 1. Monitor screen 2. Talk on/talk off (monitor off) / intercom on standby mode 3. (camera 1, 2 select) 4. Mute on/off 5. Melody select 6. Door open 7. Cctv 1, 2 select 8. Microphone 9. Menu: brightness/ contrast / color / backlight on/ off 10. Adjust down 11. Adjust up 12. Chime v...

  • Page 4: -Assembly Instructions-

    Page 4 -assembly instructions- wiring diagram.

  • Page 5

    Page 5.

  • Page 6

    Page 6 a) cable connection 1. Connect the monitor to the camera with the cable according to the wiring diagram. 2. Carefully insert the wires to the terminal by pressing down the terminal flap with any small tool taking care that the 2 bare wires do not touch. Distance between the panel and the moni...

  • Page 7

    Page 7 important ! Depending upon the installation (1 or 2 viedo monitors) the position of the dip-switches on the back of each video monitor must be set correctly (see table below) any changes to the position of the dip-swiches on either the main or optinal video monitor will require the power supl...

  • Page 8

    Page 8 icon to end intercom conversation . There is approximately 120 seconds of time before the unit automatically shuts off. 5. Activation of mute on/off when target monitor’s status is mute on and intercom function is activated, target monitor’s led will flash between red and blue, without chime ...

  • Page 9

    Page 9 button dims the leds backlights to prefered setting of dimness. When the monitor is on, button activates the menu for setting controls options of the screen brightness and contrast resolution for the picture color in view. By pressing the again, allows you to scroll through setting options. B...

  • Page 10

    Page 10 troubleshooting no. Problem check point 1 no power (no picture on monitor) check to make sure the ac plug is firmly inserted into the ac outlet. 2 power is on, but no picture on the monitor check the all cable connections to ensure that all are firmly connected between the monitor and the ca...