NavTool RGB MBCIRC Installation manual - page 3
of
7
PREPARATION FOR THE INSTALALTION
In order to prepare the Mercedes radio for the installation, open the front cover by pressing
EJECT button.
When the cover is open, disconnect the radio from power and turn the radio upside down.
Shown above is the radio prepared for installation.
Step 1
DISCONNECTING THE ORIGINAL RIBBON CABLE
Carefully pull out original ribbon cable from its compartment, remove the
plastic cover
(marked red)
and disconnect the cable from radio.
While disconnecting the cable, do not apply any force on the locks. They are very easy to break.
Be careful, and do not use sharp objects to disconnect the cable.
Step 2