NavTool RGB MBCIRC Installation manual - page 5
of
7
SECURING NAVTOOL RIBBON CABLE
Place the NavTool ribbon cable into the compartment behind the slot, where the original cable
is located.
Leave suffi
cient length of both NavTool and original cables for connecting them to NavTool
board. Make sure there is at least 1.5” on both cables is loose.
Do not use sharp objects during the procedure.
Step 5
INSTALLING NAVTOOL BOARD
Connect the loose ends of ribbon cables to the board as shown.
Make sure to connect the plugs to the appropriate slot and to insert them in the right direction.
Place the excess of the ribbon cables in same compartment as original cable.
Make sure there is long enough stripe left for attaching the board to the radio.
Step 6