NEAT Electronics DOOR User Manual

Summary of DOOR

  • Page 1

    Door door alarm user guide.

  • Page 2: Contents

    © neat electronics ab 2008 document number ne41 07003-02 v1.1 contents important information ........................................................... 3 overview ........................................................................... 4-5 installation ..............................................

  • Page 3: Important Information

    3 important information always treat your product with care. Only neat electronics authorized personnel should perform service. Do not expose your product to open flames, lit tobacco products or temperatures above 60°c. This symbol on the product or on its packaging indicates that this product shall...

  • Page 4: Overview

    4 magnet center mark overview power switch led magnet adhesives for mounting on door or wall magnet shall be within this area then door is closed.

  • Page 5: Overview

    5 overview connector for external sensor close lid using supplied screw batteries jumper mounting holes.

  • Page 6: Installation

    6 installation 1. Open the cover and insert two batteries of type aaa (lr03). 2. To enable in passage delay and out passage delay, remove the jumper from the circuit board and place it over both pins as shown on page 8. 3. Close the cover and fit the screw as shown on page 5. Mount the door alarm as...

  • Page 7: Functionality

    7 functionality door sends a radio alarm as soon as the door is opened. A new alarm is not sent until the door has been closed and is opened a second time. When an alarm is transmitted, the led on door lights up with a steady red light during up to four seconds. If door receives an acknowledgement f...

  • Page 8: In Passage Delay

    8 in- and out passage function enabled in- and out passage function disabled in passage delay if the in passage delay is enabled, door waits five seconds before sending an alarm when the door is opened. During this time, the led on door blinks with red light. If the power switch is turned off when t...

  • Page 9: Special Functions

    9 special functions the functions described on this page must be activated using a computer and the door configuration software. It is also possible to order door with these functions acitvated. Auto reset timeout it is possible to configure door with an auto reset timeout for the external alarm sen...

  • Page 10

    10 connecting door to portable receiver trex to program a trex to receive alarms from door, perform the following steps: 1. Choose programming and then add transmitter from the menu in the trex. 2. Open the door that the door alarm is mounted on. 3. The led on door lights up with a steady red light ...

  • Page 11: Declaration of Conformity

    11 declaration of conformity we neat electronics ab, varuvägen 2, 246 42 löddeköpinge, declare under our sole responsibility that our product door, ne10 07028-01, is in conformity with the directives 1999/5/ce, 73/23/ce and 89/336/cee and conforms to the standards: safety: en 60950-1:2001 emc: en 30...

  • Page 12

    Www.Neatelectronics.Com neat electronics ab varuvägen 2 246 42 löddeköpinge sweden.