NorthwesTel Pulse TV Quick Start Manual - page 14
12
13
Setting
Definition/Usage
WPS Enable
Click this checkbox to enable WPS on your system. WPS is
a standard method for easily configuring a secure connection
between your Gateway and computers or other wireless devices
(known as enrollees) that support WPS. When WPS is enabled,
you can attach other wireless devices by pressing the WPS
buttons on the device (if equipped) and on your Gateway, or
by entering the enrollee’s PIN and then clicking the Start WPS
Association icon.
Device PIN Code
Only enter this on your computer if requested during connection.
Encryption Mode
Sets the encryption method for WPS. Can be set to PBC (Push
Button Control) or PIN Code. If using PBC, press the WPS
buttons on the client device and on your Gateway simultane-
ously to start the WPS association. If using PIN codes, enter the
enrollee’s PIN in the Enrollee PIN Code field, and then click the
Start WPS Association icon. If the connection is successful, the
WPS indicator light on the Gateway stops flashing and remains
lit. If unsuccessful, the WPS light continues to flash for up to two
minutes (indicating that it’s ready to accept a client connection)
and then turns off. If the WPS light turns off, start the association
process over.
Enrollee PIN Code
If your client device has a WPS PIN, enter it here, then click the
Start WPS Association icon.
Start WPS Association
Click the WPS icon after (optionally) entering the enrollee’s PIN
to configure the network connection to the device.
Settings under Security Settings
Restore Wireless Settings to Default Settings
Settings under (Wi-Fi Protected Setup) WPS Settings:
1. Log into the Pulse TV wireless administration tool by going to 192.168.0.1.
2. Select ‘Utilities’ tab.
3. Select ‘Factory Defaults’ menu item.
4. Select ‘Factory Defaults’ button.