Nouveau Kitchens DW100N User Manual

Manual is about: 12-Place Setting Dishwasher

Summary of DW100N

  • Page 1

    12-place setting dishwasher code: 0120503607 dw100nwh dw100nss.

  • Page 2

    .1. Safety is very important close-up view (control panel) a b power light power button dial for selecting cycle handle for opening door c d carefully read the instructions contained in this manual, as it pro- vides information that is essential to safe and proper installation, use and maintenance o...

  • Page 3

    .2. Close-up view (interior) a b c d upper rack rack height adjustor top spray arm lower rack e f g washing filter bottom spray arm detergent and rinse aid dispenser technical characteristics width 60 cm depth 60 cm height 85 cm capacity 12 standard place settings mains water pressure 0.03-0.6 mpa p...

  • Page 4

    Detergent and rinse aid detergent detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "wash cycle table." the detergent dispenser is located on the inside panel the door. ...

  • Page 5

    2 1 3 4 loading the dishwasher lower rack upper rack load for 12 standard settings before placing the dishes in the dishwasher, remove the larger food particles to prevent the filter from becoming clogged. If the pots and pans have baked-on food that is extremely hard to remove, we recommend they ar...

  • Page 6

    Turning on the appliance starting a wash cycle - make sure that the appliance is plugged in and switched on. - make sure that the water supply is turned on. - load the detergent (see the section entitled, "detergent and rinse aid" on page 3). - turn the timer dial located on the right of the control...

  • Page 7

    - it is important to try and run the dishwasher when it is fully loaded to save on energy. - rather than run a full cycle for a half load, you can run the pre-rinse cycle which will prevent odours from forming and food from caking onto the dishes. - choose the right wash cycle: the choice of cycle d...

  • Page 8

    Wash cycle table cycle type of load description of cycle deter- gent rinse aid heavy rinse glassware pre-rinse very dirty dishes, pots and pans. (not to be used with delicate items). For dishes that only require a rinse and dry. Economic cycle for delicate items. Run immediately after dishes are use...

  • Page 9

    Cleaning and special maintenance filter assembly for the best performance and results, the filter assembly must be keep clean. The filter removes food particles from the wash water, allowing the water to be recirculated during the cycle. For this reason, it is a good idea to remove any food particle...

  • Page 10

    Fig.2 installation positioning the appliance position the appliance in the desired location. The back should rest against the wall, and the sides along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or left to allow co...

  • Page 11

    Installation diagram wr: wiring box ig: power switch is: door switch p1: water level switch ls: power indicator ps: drain pump ev1: inlet valve d-ed: dispenser ts.50: 50 ° c thermostat itr: overheat thermostat r: heater ml: washing motor mt: timer motor iaqs: overflow switch .10..