O Audio BASH User Manual - page 5

Other manuals for BASH: User Manual
Manual is about: Subwoofer Amplifier

Summary of BASH

  • Page 1

    O audio 500w bash ® subwoofer amplifier user’s manual page 1 of 13 copyright © 2005 o audio 500w bash ® subwoofer amplifier user’s manual.

  • Page 2

    O audio 500w bash ® subwoofer amplifier user’s manual page 2 of 13 copyright © 2005 table of contents introduction ...............................................................................................................3 warnings and cautions .....................................................

  • Page 3

    O audio 500w bash ® subwoofer amplifier user’s manual page 3 of 13 copyright © 2005 introduction: thanks for purchasing the o audio 500w bash ® subwoofer amplifier. This amplifier features bash ® technology which enables a high output power amplifier in a small package. Traditional class ab amplifie...

  • Page 4

    O audio 500w bash ® subwoofer amplifier user’s manual page 4 of 13 copyright © 2005 warnings and cautions: warning – this amplifier module is designed for installation into a subwoofer enclosure, or into its own enclosure. When properly installed, only the exterior faceplate should be accessible to ...

  • Page 5

    O audio 500w bash ® subwoofer amplifier user’s manual page 5 of 13 copyright © 2005 installation: the o audio 500w bash ® subwoofer amplifier is designed to be installed into a subwoofer enclosure or its own dedicated enclosure. Switches and other orifices are airtight. Also, the back of the facepla...

  • Page 6

    O audio 500w bash ® subwoofer amplifier user’s manual page 6 of 13 copyright © 2005 installation (continued): side view:.

  • Page 7

    O audio 500w bash ® subwoofer amplifier user’s manual page 7 of 13 copyright © 2005 installation (continued): cutout dimensions are 10.75”h x 9”w. Electrical connections to the subwoofer amplifier consist of the ac mains input, low level audio input, and speaker output. Ac mains connections are simp...

  • Page 8

    O audio 500w bash ® subwoofer amplifier user’s manual page 8 of 13 copyright © 2005 installation (continued): speaker connections are made to two spade connectors as shown in the following two photos. Positive and negative are silkscreened onto the pcb under the spades. Suitable crimp lugs have been...

  • Page 9

    O audio 500w bash ® subwoofer amplifier user’s manual page 9 of 13 copyright © 2005 installation (continued):.

  • Page 10

    O audio 500w bash ® subwoofer amplifier user’s manual page 10 of 13 copyright © 2005 control description: here is a list of controls with a brief description of function. Controls are listed in order of appearance on the amplifier starting with the upper left: gain – this control is used to set the ...

  • Page 11

    O audio 500w bash ® subwoofer amplifier user’s manual page 11 of 13 copyright © 2005 control description (continued): power – primary ac power control. Works in conjunction with the auto/on switch (see auto/on switch description earlier in this section). Service and warranty: o audio warrants the o ...

  • Page 12

    O audio 500w bash ® subwoofer amplifier user’s manual page 12 of 13 copyright © 2005 specifications (subject to change/correction without notification) : audio output power 500w rms (into 4 Ù load @ 0.3% thd) 5w-420w rms (into 4 Ù load @ 325w rms (into 8 Ù load @ frequency response refer to chart 1 ...

  • Page 13

    O audio 500w bash ® subwoofer amplifier user’s manual page 13 of 13 copyright © 2005 specifications (subject to change/correction without notification) : audio (continued) minimum load impedance 4 Ù (based on nominal driver rating) signal to noise ratio 105db phase control 0° to 180° crossover range...