Ant+ remote user manual.
Ant+remote parts the ant+remote has three buttons, which are marked with the symbols (▲, ▼ and ●). Additionally there is a red/green led located at the center. To mount the remote control a handlebar adapter and various rubber rings are provided. Mounting of ant+remote attaching on a bar the ant+rem...
Adjusting the ant+remote the ant+remote can be mounted to the left or to the right side of the handlebar. To achieve the correct key assignment the ant+remote has to be adjusted to the correct side of the handlebar. Assembly on the left side of the handlebar after you have installed the ant+remote o...
After replacing the battery, the ant+remote must be paired to the head unit (e.G. Navi2coach) again. Key functions turn off your ant+remote the ant+remote will switch automatically to standby mode after 30 seconds, when the head unit is no longer activated. Replacing the battery if the status led fl...
Overview of status-leds the following table shows an overview of the different operating conditions of the ant+remote. Please make sure that the ant+remote is activated by pressing the middle key. If the connection of ant+remote to your head unit will not be established correctly or even terminated,...
Warranty we are only liable for damages in accordance to the statutory regulations in respect to our contractual partners. Batteries are excluded from warranties. In case of a warranty please contact the retailer where you purchased your device. Batteries can be returned after use. This product is c...