Ocean Breeze OBZ-05CM Owner's Manual - page 6
NOTE:
The power supply cord with this air
conditioner contains a current detection
device designed to reduce the risk of fire.
Please refer to the section ’Operation of
Current Detection Device‘ for details. In
the event that the power supply cord is
damaged and cannot be repaired, it
must be replaced with a replacement
from the Product Manufacturer.
WARNING
Avoid fire hazard or electric shock. Do not
use an extension cord or an adaptor plug.
Do not remove any prong from the power
cord.
Grounding type wall
receptacle
Do not, under any
circumstances, cut,
remove, or bypass
the grounding prong.
Power supply cord
with 3-prong grounding plug
and current detection device
WARNING
For Your Safety
WARNING
Prevent Accidents
WARNING
Electrical Information
Do not use gasoline or store any other flammable vapors and liquids in the vicinity
of this or any other appliance.
(Applicable only to certain units with current
detection device plug)
The power supply cord contains a current detection device
that senses damage to the power cord. To test your power
supply cord do the following:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO buttons on the plug
head. Press the TEST button, you will notice a click as the
RESET button pops out.
3. Press the RESET button, again you will notice a click as
the button engages.
4. The power supply cord is now supplying electricity to the
unit. (On some products this is also indicated by a light on
the plug head.)
3
To reduce the risk of fire, electrical shock, or injury to persons when using your
air conditioner, follow basic precautions, including the following:
Be sure the electrical service is adequate for the model you have chosen. This
information can be found on the serial plate, which is located on the side of
the cabinet and behind the grille.
If the air conditioner is to be installed in a window, you will probably want to clean
both sides of the glass first. If the window is a triple-track type with a screen panel
included, remove the screen completely before installation.
Be sure the air conditioner has been securely and correctly installed according to
the installation instructions in this manual. Save this manual for possible future
use in removing or installing this unit.
When handling the air conditioner, be careful to avoid getting cut from sharp
metal fins on front and rear coils.
To reduce the risk of fire, electrical shock, or injury to persons when using your
air conditioner, follow basic precautions, including the following:
Be sure the air conditioner is properly grounded. To minimize shock and fire
hazards, proper grounding is important. The power cord is equipped with a
three-prong grounding plug for protection against shock hazards.
Your air conditioner must be used in a properly grounded wall receptacle. If the
wall receptacle you intend to use is not adequately grounded or protected by a
time delay fuse or circuit breaker, have a qualified electrician install the proper
receptacle. Ensure the receptacle is accessible after the unit installation.
Do not run air conditioner without side protective cover in place.This could
result in mechanical damage within the air conditioner.
Do not use an extension cord or an adapter plug.
Do not use the current detection device to turn the unit on or off.
Always make sure the RESET button is pushed in for
correct operation.
The power supply must be replaced if it fails to reset when
either the TEST button is pushed or it cannot be reset.
If power supply cord is damaged and cannot be repaired,
it MUST be replaced with a replacement from the product
manufacturer.
NOTE:
NOTE:
This air conditioner is designed to be operated
under
normal
temperature conditions as follows:
Cooling
operation
Outdoor temp:
Indoor temp:
IMPORTANT SAFETY INSTRUCTIONS
O
O
O
O
64-109 F/18-43 C (64-125 F/18-52 C
for special tropical models)
O
O
62-90 F/17-32 C
Note: Performance may decrease outside of these
normal
operating temperatures.
‘Operation of Current Detection Device’