Ocean Breeze OBZ-05CM Owner's Manual - Installation Instructions
13” (330mm)
5,000
BTU/Hour
10,000 ~ 12,000
BTU/Hour
15 1/2” (394mm)
Height
Model
Lower sash must open sufficiently to allow a clear
vertical opening (H) of following size (see Table 1).
Side louvers and the rear of the AC must have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit must
be outdoors, not inside a building or garage.
PREPARE THE WINDOW
1
1
PREPARE AIR CONDITIONER
2
2
1. Remove the air conditioner from the carton and
place on a flat surface.
2.
Remove top rail from the packaging material as
shown in Fig. A.
Top Rail Hardware
3/8 Screws
(4)
Top Rail
(1)
Packaging
Fig.A
Top Rail
3. Align the hole in the top rail with those in the top
front of the unit as shown in Fig.B
4. Secure the top rail to the unit with the 3/8''
Screws as shown in Fig.C.
NOTE:
For safety reasons, all four(4) screws MUST
be securely fastened.
Fig.B
INSTALL THE ACCORDION PANELS
3
3
NOTE:
Top rail and Sliding Panels at each side are
offset to provide the proper pitch to the rear of (5/16 ).
This is necessary for proper condensed water collection
and drainage. If you are not using the Side Panels
for any reason, this pitch to the rear must be maintained.
1.Place unit on floor, a bench or
a table. Hold the Accordion
Panel in one hand and gently
pull back the center to free the
open end. See Fig.1
Fig.1
INSTALLATION INSTRUCTIONS
5
Table 1
Fig.C