1. DL manuals
  2. Ofna Racing
  3. Battery Charger
  4. DIGIPEAK-3
  5. Manual

Ofna Racing DIGIPEAK-3 Manual

Summary of DIGIPEAK-3

  • Page 1

    Features: 1.Super function 3 in 1 16 bits microchip cpu controller 2. Ac, dc are both compatible ac 110v or 230v switching power supply technologyinput dc 11v ~ 18v input usabl e 3. Two-line 16 characters dot matrix large lcd display 4. Ac & dc's plug sockets are removable 5. Universal output termin...

  • Page 2: Charge Mode

    Charge mode 1.Main menu -> press the (enter) into charge mode. 2.Set the current rate before charging. Adjustable charge rates from 300ma-5000ma. The default current is 2a, you can use the +(increase) and -(decrease) button to adjust the charge rate. See the table below to select the charge rate for...

  • Page 3: Operation Instruction

    Plug the charger into an ac 110v/230v wall outlet or a dc 12v power source. The charger power is on now and the lcd displays the main menu. The lcd displays the data below. If you need to stop charging, press the s(start) button to stop it, and then press the start button to go back to the main menu...

  • Page 4: In Ni-Cd Or Ni-Mh Mode

    Charging process set the charge current min. Charge current is 0.3a max. Charge current is 5a discharging process charge after discharge process ni-cd charge c=2.0a ni-cd 'charge' c=2.0a ni-cd 'discharge' d=0.5a end=6.0v ni-cd 'disc? Chg' 0.5a/6.0v? 2.0a + + - - + + + - - - ni-cd charge c='5.0a' ni-...

  • Page 5: In Li-Po Mode

    S s in li-po mode min. Charge current is 0.3a max. Charge current is 4a 1 cell 2 cell 3 cell min. Discharge current is 0.3a max. Discharge current is 2a press the s(start) button within 2 sec. To go back to the main menu. Start charging charging process discharging process li-po 'charge' c=2.0a 7.4v...

  • Page 6: Beep Setup

    Tone on tone off beep setup + - tone enable tone 'enable' tone 'disable' tone enable tone disable lcd display problem factor [error] the output terminal is reverse polarity connected inversely to the polarity of the battery pack. [error] short circuit protection for output short the output terminal....

  • Page 7: Safety Precautions :

    Safety precautions : 1.Please check the voltage in your house if it's consistent to this charger, you can only use it when the voltages are the same. 2.Do not allow children to charge battery packs unless supervised by a responsible adult. 3.Use only rechargeable batteries. This charger cannot charg...