?oleman FL8-UH Installation Instruction - Warning
035-17405-000 Rev. B (0801)
2
Unitary Products Group
IMPROPER INSTALLATION MAY CREATE A
CONDITION WHERE THE OPERATION OF THE
PRODUCT COULD CAUSE PERSONAL INJURY
OR PROPERTY DAMAGE.
IMPROPER INSTALLATION, ADJUSTMENT,
ALTERATION, SERVICE OR MAINTENANCE
CAN CAUSE INJURY OR PROPERTY DAMAGE.
REFER TO THIS MANUAL FOR ASSISTANCE
OR ADDITIONAL INFORMATION, CONSULT A
QUALIFIED INSTALLER, SERVICE AGENCY OR
THE GAS SUPPLIER.
THIS PRODUCT MUST BE INSTALLED IN
STRICT COMPLIANCE WITH THE ENCLOSED
INSTALLATION INSTRUCTIONS AND ANY
APPLICABLE LOCAL, STATE, AND NATIONAL
CODES INCLUDING BUT NOT LIMITED TO,
BUILDING, ELECTRICAL AND MECHANICAL
CODES.
The furnace area must not be used as a broom
closet or for any other storage purposes, as a fire
hazard bay be created. Never store items such as
the following on, near or in contact with the fur-
nace.
1.
Spray or aerosol cans, rags, brooms, dust mops,
vacuum cleaners or other cleaning tools.
2.
Soap powders, bleaches, waxes or other cleaning
compounds; plastic items or containers; gasoline,
kerosene, cigarette lighter fluid, dry cleaning fluids
or other volatile fluid.
3.
Paint thinners and other painting compounds.
4.
Paper bags, boxes or other paper products
Never operate the furnace with the blower door
removed. To do so could result in serious personal
injury and/or equipment damage.
WARNING
CAUTION
WARNING
GENERAL INFORMATION
DESCRIPTION
This Category I furnace is designed for installation in a resi-
dential or commercial application. A Category I furnace has a
fan assisted combustion system equipped with an integral
mechanical means to draw products of combustion through
the combustion chamber and heat exchanger. It may be
installed in a basement, garage, equipment room, alcove,
attic or any other indoor location where all required clear-
ances to combustibles and other restrictions are met. It is
designed for natural gas-fired operation, for use in standard
and LoNox applications.
High altitude and propane (LP) changes or conversions
required in order for the appliance to satisfactorily meet the
application must be made by an authorized distributor: in
Canada, a certified conversion station or other qualified
agency, using factory specified and/or approved parts.
Upflow/horizontal furnaces and downflow furnaces may be
used only as Category I units.
The furnace must be installed so that all electrical compo-
nents are protected from water.
INSPECTION
As soon as a unit is received, it should be inspected for possi-
ble damage during transit. If any damage is evident, the
extent of the damage should be noted on the carrier's freight
bill.
A separate request for inspection by the carrier's agent should
be made in writing. Also, before installation, the unit should be
checked for screws or bolts which may have loosened in tran-
sit.
NOTES, CAUTIONS & WARNINGS
The installer should pay particular attention to the words:
NOTE, CAUTION and WARNING. NOTES are intended to
clarify or make the installation easier. CAUTIONS are given
to prevent equipment damage. WARNINGS are given to alert
the installer that personal injury and/or equipment or property
damage may occur if installation procedures are not handled
properly.
LoNOX furnaces requiring propane (LP) gas must
have the LoNOX screens removed prior to installa-
tion and operation. See propane instruction 035-
14445-000 for instructions on proper removal of
the Nox screens.