Xpj projector owner’s manual updated nov 15, 2010 - 2 - introduction congratulations and get ready to really change the way you watch movies or t.V., play games, view pictures, surf the internet and so much more! The xpj projector is a projector for you to use and play with just like you’ve always w...
- 3 - table of contents important safety information precautions 4 operating instructions features of your projector 6 using your projector 7 storing your projector 8 turning off your projector 9 helpful information menu options 10 remote operation 12 replacing the lamp 15 replacing the fuse 18 tech...
- 5 - precautions to avoid possible damage to projector or user place the projector on flat surfaces only, preferably wood, glass, marble or steel. do not place the projector on a plastic surface; the plastic may melt. do not block the vent openings on the sides of the projector; this may c...
- 7 - operating instructions using your projector 1. Place the projector on a flat surface at least 30 inches (76cm) from the floor. Pull the kickstand out from the bottom of the projector. 2. Position the projector so the lens is 6-10 feet (2- 3 meters) away from where you want the image projected....
- 9 - operating instructions turning off your projector important use only these steps to power down, never use the power switch alone to turn off projector. This will cause the projector to over heat and break down. 1. Press the standby button on projector or the on/off button on the remote. 2. Wai...
- 11 - helpful information menu options (cont’d) audio volume increases and decreases volume (see “remote operation” for other volume adjusting methods) utility sleep timer shuts projector down automatically after chosen time; time in increments of 30 minutes r/l reverse flips image horizontally u/d...
- 13 - helpful information remote operation (cont’d) projector buttons key controls: corresponds to remote key: i menu menu ◄ ► enter/exit on/off power left right exit - 14 - helpful information remote operation (cont’d) how to use your remote control 1. Press to enter the main menu. 2. Scroll to de...
- 15 - helpful information replacing the lamp never touch the insides of this unit or the lamp glass when replacing the lamp never use tools other than the hooks on the underside of the new lamp to remove the old lamp 1. Using a coin, turn counter-clockwise to release the screw from the lamp cover (...
- 17 - helpful information replacing the lamp (cont’d) figure 4. Removing the old lamp (pull up) note: keep the old lamp away from children and do not touch with bare hands as it is hot! 5. Insert the new lamp into the lamp chamber and gently push down until the lamp snaps into place. Never touch th...
- 19 - helpful information technical summary resolution 640 x 480 pixels (vga) projection 50 inches at 2 meters support composite video (av) – rca jack s-video vga / pc jack power ac / 120v lumen flux 300 lm audio built-in stereo 2w x 2 speakers life of lamp 300 hours (easy to replace) control keys ...
- 21 - if something goes wrong troublshooting tips (cont’d) problem 2. Remote will not function 3. Projector will not turn on solution a. Confirm batteries are properly installed in the remote control. B. Replace the batteries. C. Be sure nothing is covering the ir sensor on the projector. A. Confir...
- 23 - miscellaneous quick start guide 1. Remove projector, power cord, and remote control from package. 2. Install batteries in remote control and connect power cord to ac mains. 3. Connect a s-video, rca, or pc video cable to projector. 4. Remove the lens cover and turn on main power by pressing t...
- 25 - miscellaneous appendix b figure 3: focusing the lens m turn to focus image - 26 - miscellaneous glossary brightness: the amount of light displayed contrast: the intensity of the light displayed hue: the amount of color displayed input mode: settings that are changed to be compatible with the ...
