Alarm system gsm&pstn intelligent gsm&pstn auto-dial alarm system for a better understanding of this product, please read this user manual thoroughly before using it. Profile alarm system 2013.5.V1.0 gsm&pstn gsm level 99% disarm 8:32pm 05 /01/13 wed.
Contents i. Function instruction…………………………… 1 ii. Alarm panel introduction…………………………………2 iii. Initialization…………………………………………………4 iv. Function settings…………………………………………4 1. Enter settings………………………………………………5 2. Time setting…………………………………………………5 3. Alarm call & sms number setting…………………………5 4. Sms attent...
1 function instruction touch keypad and large dot-matrix lcd screen with perpetual calendar and detailed display; gsm and land line (pstn) dual network alarm; support 5 user alarm phone numbers (call or sms), 1 alarm center number and 1 sms attention number; 30 wireless defense zones and 4 wired zon...
Keypad buttons instruction: indicating tone: iii 1)put sim card: please insert a valid sim card into the card slot. (please make sure the power is off.) 2)connect telephone line: connect the telephone line in your house to the port “tel-in”. There's a cable in the standard kit. It could connect your...
5 6 4) if there’s no operation over 30seconds, the panel would exit setting status automatically. 1.Enter settings press , then input the 4-digit program password and to enter setting status. (default password: 1234) 2.Time setting after enter settings, you could see “clock setting”. Enter it to set...
5.Voice recording enter “voice recording” and press to choose on. Enter it; you can start the 10-second recording. After 10s, it will exit automatically. Press or can end the recording manually. Receivers can hear this recording when there’s an alarm call. 6.Arm delay setting enter “arm delay” menu....
Arm & disarm horn: turn on this function; the extern siren will make one short beep for arm operation and two short beeps for disarm. 11.Ring time setting when you use phone to call the alarm system and do remote control, it will get through after several rings. This ringing times could be set (1~9)...
14.Alarm center setting enter “cms upload” menu, you can do all the following settings: cms no. Setting: this is the alarm center number (this number could not exceed 15-digit). User id setting: delete the preset numbers and input the new id (0001~9999). (default: 0001) status upload: press to choos...
Alarm and working record. Press to upturn or downturn. This system can store 100 records. The last status is ranked as the first record. And when the record number exceeds 100, the most previous record will be deleted automatically. 19.Factory reset when the system is unstable, it is recommended to ...
Enable some of the detectors (such as sensors for door, window, balcony, etc), and disable the others (such as sensors for the hall or some places easy to be triggered by person at home). Main unit operation: press button on keypad remote control operation: press button on remote controller once lcd...
Vi.Technical parameters main panel input voltage: dc12v/ 1.2a standby current: alarming current: gsm band: 850/900/1800/1900mhz wireless frequency: 315/433/868mhz (default: 433) backup battery: 3.7v/ 1200ma li rechargeable battery standby time: 10~12hrs recharging time: 12hrs working temperature: 10...
Signal booster door sensor pir detector remote controls 18 19 care and maintenance care and maintenance without approval and consent of relevant authorities, please do not set “112”, “911” or the alarm phone number of police station for this main unit. Please read the suggestions above carefully and...
