PAC C2R-CHYNA Installation Instructions
Pacific Accessory Corporation
1502 S. Santa Fe St. Santa Ana, CA 92705
Voice: 714-835-3022 • Fax: 714-835-3233
www.pac-audio.com
10-12-06
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the C2R-CHYNA parts be held liable for consequential
damages sustained in connection with the C2R-CHYNA. The manufacturer and it’s distributors will not, nor will they authorize any
representative or any other individual to assume obligation or liability in relation to the C2R-CHYNA other than its replacement.
Installation:
1.
Only for Vehicles Without a Factory Amplifier: Connect the aftermarket radio’s front and rear speaker wires to the 22 pin plug.
2.
The 22 pin harness has two yellow and two black wires. Connect both yellows to the radio’s +12v constant wire and both blacks
to the radio’s ground wire.
3.
The Accessory wire is located on the 6 pin harness - connect this wire to the radio’s accessory wire. The accessory wire supplies
+12v, 1 amp max, when key is in the Accessory or Ignition position.
4.
11 pin plug: Orange/White - Connect this wire to the radio’s Illumination input wire only.
Note: Do not connect these wires to any other circuit besides the radio’s wire harness.
5.
When all connections are made, connect the 22 pin plug into the vehicle’s 22 pin harness.
9
7
8
0
1
11
1 amp
fuse holder
1
#
2
#
t
u
pt
u
O
yr
o
s
s
e
c
c
A
.
x
a
m
p
m
a
1
st
l
o
v
2
1
+
22 pin
Chrysler R
6 pin
Orange/White = Illumination
Yellow x 2 = +12v Constant
Black x 2 = ground
Gray = Right Front (+)
Gray/Black = Right Front (-)
White = Left Front (+)
White/Black = Left Front (-)
Violet = Right Rear (+)
Violet/Black = Right Rear (-)
Green = Left Rear (+)
Green/Black = Left Rear (-)
Red = +12v Accessory output
To optional SWI-CAN interface for retaining steering wheel audio controls
11 pin
C2R-CHYNA
C2R-CHYNA
Radio Replacement interface for 2004+
Chrysler, Dodge and Jeep vehicles
with Factory Radio Models REF, REC, RAQ and RAK.
1
2
3
4
5
6
For Use with Aftermarket Radios to Retain Accessory Power
• Retains Accessory Power for Approximately 10 Minutes or Until A Door is Open