1. DL manuals
  2. PlaySafe
  3. Toy
  4. 22-PS110
  5. Owners Manual And Assemly Instruction

PlaySafe 22-PS110 Owners Manual And Assemly Instruction

Manual is about: Verona II Swing Set

Summary of 22-PS110

  • Page 1

    1 ©2006 pacific cycle, inc. Owner’s manual and assembly instruction model #: 22-ps110 model name: verona ii swing set manual date: october, 2006 important: keep this owner’s manual; do not discard in case you need to contact pacific cycle, inc. In the future. Should there be a change of ownership, p...

  • Page 2

    2 ©2006 pacific cycle, inc. To make claim under warranty, notification of such defect must be given to pacific cycle, inc. By calling the phone number below, you will be instructed on how the product or part needing replacement should be shipped postpaid to pacific cycle, inc. Customer service and a...

  • Page 3

    3 ©2006 pacific cycle, inc. Warnings and safety information o bserve all warnings and statements in order to reduce the risk of injury or death . • before you assemble the swing set , find level ground not less than 6 feet from any structure or obstruction to the swing set . Y our swing set must hav...

  • Page 4

    4 ©2006 pacific cycle, inc. Proper use this swing set is designed for use by children ages 2 to 10 under adult supervision. The maximum number of users this unit is intended for is 5 children with a maximum weight of 105 lbs each. The maximum fall height for this swing set is 74”. Single ride (i.E. ...

  • Page 5

    5 ©2006 pacific cycle, inc. The information is intended to assist in comparing the relative shock-absorbing properties of various material. No particular method is recommended over another. However, every material is only effective when properly maintained. Materials should be checked periodically a...

  • Page 6

    6 ©2006 pacific cycle, inc. Pre-assembled hardware for easier assembly, playsafe™ has pre-assembled some of the parts for you. Most of the screws and bolts should already be in place. If removal of this hardware is required for certain assembly steps, it should be replaced in its original position. ...

  • Page 7

    7 ©2006 pacific cycle, inc. 4 remove the hardware from the middle section of a leg. Match up the holes of the mid-leg and support bar and re-insert the hardware through both. Repeat the process for the opposite side and center legs. It may be necessary to pull both legs towards each other in order f...

  • Page 8

    8 ©2006 pacific cycle, inc. 2 attach the two vertical poles to the glider attachment. Start by removing the hardware from the lower section of the glider attachment. Align the vertical bar with the glider attachment and re-insert the hardware. Repeat the process for the other side. Note: the curved ...

  • Page 9

    9 ©2006 pacific cycle, inc. Swing and trapeze assembly pre-assembled parts • swing seats should be attached to the chain. Step illustration instructions hardware reference 1 hang the swings and trapeze in place from the swing hooks. 2 check the lock nut and bolt on the swing seat to make sure that t...

  • Page 10

    10 ©2006 pacific cycle, inc. Step illustration instructions hardware reference 1 remove the screws, washers, and lock nuts from the holes in the slide. Part ref. #: pshw24 2 insert the rail/ladder legs through the holes in the top of the slide. Align the ladder holes with the slide holes. 3 insert t...

  • Page 11

    11 ©2006 pacific cycle, inc. Important last steps! Tighten all hardware. Do not allow children to play on the swing set until it is fully assembled, all items are tightened, and the unit is properly anchored. • do not over tighten nuts and bolts. Once they are tight, turn them ½ rotation more to be ...